Mimio MimioTeach User manual

Step 1: Remove contents from
box.
Step 2: Install software from Self
Service not from disk that came in
box. It is called “Mimio Studio 9.12
updated package” and you can find
it in the featured section or the
interactive whiteboard section.
Once installed, the software can be
found in the “Mimio” folder in your
applications folder.
Step 3: Connect the USB cable
to the USB power supply.
Step 4: Connect the other end
of the USB cable to the bottom
of the MimioTeach bar. Plug the
power supply to the electrical
outlet.
Step 5: Unscrew the top of the
Stylus and remove the tag that
protects the battery during
shipping.
Step 6: Attach the MimioTeach
to the left side of the whiteboard.
MimioTeach Hardware Set Up Guide

Step 7: Place the stylus in it’s
docking station on the
MimioTeach bar for charging.
Step 8: Connect the Hub
receiver into a USB port on your
computer.
Also launch the Notebook
software from the Mimio folder
within the Applications folder.
Step 9: Press the “Calibrate”
button on the MimioTeach bar.
Step 10: Make sure to turn on
projector to calibrate
MimioTeach bar. Follow the
onscreen directions to calibrate.
Status Lights: The status light
on the MimioTeach bar will tell
you the status of the connection
between the bar, power source
and computer/software.
Note: The status light is also the
power button.
MimioTeach Hardware Set Up Guide