Mini Gadgets HS10000 PT User manual

Instructions for HS10000 PT - Pan Tilt Monitor
Welcome
Thank you for purchasing the new top of the line HS10000 PT. The
following product manual will help you to install and operate your new
device. Please be sure to fully read the directions before proceeding to use
your new HS10000 PT.
Installation
1.) Place the camera in your desired location.
2.) Plug the camera into a standard wall outlet via the included power
adapter.
3.)Slide the power switch to the ON position. The power indicator lights
should light up.
4.) Either connect the receiver via the power adapter or load 4 AAA batteries
into the battery compartment, being sure to match the polarities. Slide the
power switch to the ON position. (Note: If you both place batteries and plug
the unit it, it will draw power from the adapter instead of the batteries.
Please remove the batteries if left unused for long periods of time.)

5.) Set the channel on the receiver unit to be the same as that of the camera
by pressing the CHANNEL button continuously; the picture will be
displayed on the LCD screen. (Note: For improved clarity, please connect
the receiver to a monitor or TV with AV cables.)
6.) On the side of the receiver you will find a volume control roller as well
as a brightness control roller. Adjust both volume and brightness to desired
level.
Receiver Remote Control Function
The receiver can remotely control the power and direction of the camera, please follow
the directions below for use.
Remote control of camera's power
1.) Press the CTRL button to turn on/off the LCD screen and keep voice
enabled.
2.)Press and hold the CTRL button for three seconds to turn on/off the
camera remotely.
Note: The channel indicator will indicate which camera you are
remote controlling. Ex: If the display on the receiver lights up CH1,
then the camera at CH1 will be controlled.
Remote control of the camera's direction
1.) Press the AUTO button once on the receiver to activate the camera's
automatic horizontal rotation for a period of time.
2.) Press the ◄/►buttons on the receiver to rotate the camera horizontally
manually. The maximum angle is 270°.
3.) Press the ▲/▼buttons on the receiver to rotate the camera vertically.
The maximum angle is 120°.

Channel looping setup
1.) The receiver supports up to 3 cameras working at the same time. You can
press and hold the CHANNEL button on the receiver for 2 seconds to
enable the automatic looping function. The channels will be shown and then
cycled through to the next channel every 8 seconds.
2.) Press the CHANNEL button on the receiver again to exit the looping
function.
3.) You can then once again press the CHANNEL button to manually select
a channel.