Safety instructions P40, W40
6
zThe cooling device is not suitable for transporting caustic mate-
rials or materials containing solvents.
ezOnly connect the device as follows:
– With the DC cable (fig. 12, page 3) to a DC plug socket in
the vehicle (e. g. cigarette lighter)
– Or with the 230 V connection cable (fig. 13, page 3) to the
230 V AC mains supply
zNever pull the plug out of the socket by the cable.
zIf the connection cable is damaged, it must be replaced with the
cable of the same type and specifications.
zDisconnect the device from the mains.
– Before cleaning and maintenance
– After use
zIf the cooler is connected to the DC socket: disconnect the
cooler or switch it off when you turn off the engine. Otherwise
you may discharge the battery.
zOn boats: if the device is powered by the mains, ensure that the
power supply has a ground fault interrupter circuit. Danger of
fatal injuries!
zDisconnect the cooling device and other power consuming
devices from the battery before connecting the quick charging
device.
zCheck that the voltage specification on the type plate corre-
sponds to that of the energy supply.
1.2 Operating the device safely
azBefore starting the device, ensure that the power supply line
and the plug are dry.
zDo not place the device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
zCaution! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that arises during operation does not build up. Make sure
that the device is sufficiently far away from walls and other ob-
jects so that the air can circulate.
zDo not fill the inner container with ice or fluid.
zNever immerse the device in water.
zProtect the device and the cable against heat and moisture.
_P40_W40.book Seite 6 Donnerstag, 2. Dezember 2010 1:55 13