modway EEI-3705-NAT-GRY User manual

A
C
F
Bolt M6x60mm x 2
Bolt M6x35mm x 4
Allen Wrench M4 x 2
x1
x2
EEI-3705-NAT-GRY CHAIR
Hardware:
Component:
Page 1 of 3
Thank you for purchasing the MODWAY CHAIR!
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Customer Service 609-256-9000 www.modway.com
1. Back
2. Seat
3. Leg Frame
x1
1
2
3
4
4. Back Cushion x1
BNut M6 x 2
Cap M6 x 4
Screw M6x45mm x 2
D
E
5. Seat Cushion x1
5
The assembly steps are the same as single chair

Page 2 of 3
Hardware & Tool required
Hardware & Tool required
Customer Service 609-256-9000 www.modway.com
EEI-3705-NAT-GRY CHAIR
3
32
F
B
FF
DC
1
A
F
STEP 1:
Attach 1 piece of Leg Frame (3) to Seat (2) as shown.
Insert 1 piece of Nut (B) into Seat (2),then insert 1piece of Bolt (A) through Leg Frame (3) into Seat (2).
Tighten with 2 pieces of Allen Wrench (F).
Repeat the same steps for the remaining Leg Frame (3).
x2
A
x2
B
x2
F
x4
C
x4
D
x2
F
STEP 2:
Attach Back (1) to Leg Frame (3) as shown.
Insert 4 pieces of Caps (D) into Back (1),then insert 4 pieces of Bolt (C) through Leg Frame (3) into Back (1).
Tighten with 2 pieces of Allen Wrench (F).

Carefully position the assembled chair to the desired location.
Put 1 piece of the Back Cushion (4) and 1 piece of the Seat Cushion (5) into the assembled chair as shown.
Page 3 of 3
Hardware & Tool required
STEP 4:
Assembly is complete. Your chair is ready to be used now!
Customer Service 609-256-9000 www.modway.com
EEI-3705-NAT-GRY CHAIR
F
E
4
x2
E
x1
F
STEP 3:
Insert 2 pieces of Screws (E) through Back (1) into Leg Frame (3).
Tighten with Allen Wrench (F).
5