Moen Fina YB9222 User manual

1. Position the mounting template on the wall in the desired location.
Using a level, align the template and tape it to the wall.
2. Remove each mounting post from the body by loosening the setscrew.
3. Place each mounting post on the template with notch facing down.
4. Mark the 2 large hole locations of each mounting bracket.
5. Attach each mounting bracket to the wall, using the wall anchors
provided
6. Mount each base on the corresponding mounting bracket. Check and
make sure that the base set screw hole(s) are facing down. Assemble
a set screw to each base. Use the allen wrench included in hardware
kit to tighten each set screw and secure the assembly to the mounting
bracket(s).
7. Tighten all 4 screws. Do not over tighten.
8. Assemble the Towel bar and posts.
9. While assembled, Position each end post with the setscrew down and
place over mounting post. Tighten the setscrew at the bottom of each
base.
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] •FAX: [phone]
INTERNATIONAL: [phone] •FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 •FAX: [phone]
WWW.CSI.MOEN.COM

Copyright Creative Specialties International Literature #BA1454
Double Towel bar
posts are constructed
of zinc. Bars are constructed of
aluminum.
q
YB
92
22BN
–
24” Double Towel Bar
Brushed Nickel Finish
qYB9222CH – 24” Double Towel Bar
Chrome Finish
Cleaning Instructions:
Stock Number:
__________________Double Towel Bar
By CSI Bath Furnishings
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Double Towel Bar
YB
9
2
22
Fina™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.