
EN - 12
Using too little detergent can result in poor
cleaning and you can see whitish streaks
in hard water.
See the detergent manufacturer’s
instructions for a further information.
4.9. Filling with detergent
Push the button on the cap to open the
dispenser and pour in the detergent.
To close the cap slide and press it until it
locks in place. The dispenser should be
refilled just before the start of each
programme.
DETERGENT
4.10. Using combined detergents
These products should be used according
to the manufacturer’s instructions.
When using combined detergents it is
important to reduce the salt and rinse aid
level to the lowest setting.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the combination.
We recommend you do not use combined
detergents in short programmes.
Please use powder detergents in such
programmes.
If you encounter problems when using
combined detergents, please contact the
detergent manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to the required level.
4.11. Rinse-aid usage
The rinse aid helps to dry the dishes
without streaks and stains. Rinse-aid is
required for stain-free utensils and clear
glasses. The rinse aid is automatically
released during the hot rinse phase. If
rinse aid dosage setting is set too low,
whitish stains remain on dishes and dishes
do not dry or wash properly.
If rinse aid dosage setting is set too high,
you can see bluish layers on glass and
dishes.
4.12. Filling the rinse-aid and setting
To fill the rinse aid compartment, open the
rinse-aid compartment cap. Fill the
compartment with rinse aid to the MAX
level and then close the cap. Be careful not
to overfill the rinse aid compartment, if this
happens run the dishwasher through a
short cycle
In order to change the rinse aid level,
follow the below steps before turning on
the machine:
The factory setting is “4”.
If the dishes are not drying properly or are
spotted, increase the level. If blue stains
form on your dishes, decrease the level.
Level Brightener Dose Indicator
1 Rinse-aid not
dispensed
r1 is shown on the
display.
2 1 dose is
dispensed
r2 is shown on the
display.
3 2 doses are
dispensed
r3 is shown on the
display.
4 3 doses are
dispensed
r4 is shown on the
display.
5 4 doses are
dispensed
r5 is shown on the
display.
• Push the programme button and hold it
down.
• Turn on the machine.
• Hold down the programme button until
“rA” disappears from the display. Rinse
aid setting follows water hardness
setting.
•The machine will display the current
setting
•Change the level by pushing the
programme button
•Switch off the appliance to save the
setting