
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE EARTH CABLE
DO NOT USE AN ADAPTOR
DO NOT USE AN EXTENSION LEAD
Failure to follow these instructions can result in death, fire or electrical shock.
Before you move your refrigerator into its final location, it is important to make sure you
have the proper electrical connection
Recommended Earthing Method
A 220~240 Volt/60 Hz AC only 10 amp fused and properly earthed electrical supply is
required. it is recommended that a separate circuit serving only this appliance be
provided. Use a socket which ideally cannot be turned off with a switch or pull chain. Do
not use an extension cord. NOTE: Before performing any type of installation, disconnect
the refrigerator from the electrical source. When you are finished, connect the
refrigerator to the electrical source and reset the control to the desired setting.
LEVELING
If the refrigerator is not leveled during installation. The doors may not close or seal
properly, which causing cooling, frost or moisture problems. It is very important for the
refrigerator to be leveled in order to function properly
To level your refrigerator, you may either turn the level leg clockwise to raise that side
of the refrigerator or turn counter-clockwise to lower that side.
USE OF THE APPLIANCE
Your unit has only one control for regulating the temperature in the
compartment. The temperature control is located on the upper right-hand side of the
compartment.
The first time you turn the unit on, set the temperature control to “7”.
The range of the temperature control is from position "OFF” to “7”. After 24 to 48 hours,
adjust the temperature control to the setting that best suits your needs. For UK
homes, the ideal setting on this fridge is setting 5 on the knob control, otherwise please
adjust to suit.
To turn the appliance off, turn the temperature control to “OFF”.
NOTE:
Turning the temperature control to “OFF” position stops the cooling cycle but does not
shut off the power to the unit. If the unit is unplugged, has lost power, or is turned off, you
must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before
this time delay, the unit will not start.
PROLONGED OFF PERIODS
If the refrigerator is not used for a long period of time, proceed as follows:
Disconnect the refrigerator from the main supply by removing the plug from the wall
socket Clean and dry the inside as instructed under the heading before using your
fridge. Leave the door open to prevent any unpleasant smells from building up while the
refrigerator is not in use.