Monument Grills S1251801T User manual

MONUMEMTPELLET GRILL
USE AND CARE MANUAL
S1251801T
Please read this entire manual before installation and use of this pellet fuel-burning
appliance.
Failure to follow these instructions could result in property damage, bodily injury
or even death.
Contact local building or fire officials about restrictions and installation
inspection requirements in your area.
Save these instructions.
THIS Pellet Grill IS DESIGNED FOR OUTDOOR USE ONLY
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
WWW.MONUMENTGRILLS.COM

Guide directory
1. Safety warning page 3-4
2. Certificationsticker Page 5
3. ExplodedView Page 6
4. Single part list Page 7
5. Fixingelements Page 7
6. Mountingsteps Page 7--18
7. Use of smokedstove Page 19-20
8. Button function description Page 21-23
9. Troubleshootingcommonfaults Page 23

1.Safetywarning
※Please read the entire manual carefully before assembling and using the
smoker, and install and use it as required. The company will not be responsible
for property damage, personal injury or even death caused by failure to follow
the instructions.
※About carbon monoxide poisoning: All cooking ovens or cooking utensils
produce organic gases (such as carbon monoxide) when burning materials
(such as wood, gas or charcoal). Carbon monoxide can impair the ability of the
blood to deliver oxygen, which can lead to loss of consciousness or death. If you
have headaches, dizziness, weakness, nausea, vomiting, nasal congestion,
lethargy or confusion in your use, please seek medical advice.
※Be sure to use the device in an open area outside and away from inflammable
and explosive materials (minimum 40 inches).
※This equipment is equipped with an ignition system.Do not use gasoline,
gasoline fuel, kerosene, barbecue charcoal or special ignition liquid to ignite.
※Please use the grounding socket that meets the local safety regulations. If you
need to reinstall the socket, please follow the local electrical code.
※Dangerous voltage can cause shock, burns or death. In case of equipment
failure, please follow the instructions or contact the local after-sales personnel
for maintenance. Please cut off the power before maintenance.
※During the use of the device, there is a high temperature in the local position.
Do not move the device at will, and pay attention to the elderly and children.
Beware of burns.
※Please clean up the remaining fuel after each use, because the fuel may
expand and clogging the feeding mechanism.
※Please use the wood pellets for the smoker to ensure that the particle
diameter is not more than 0.3 inches and the length is not more than 1.2 inches.
If the particles are too large, the equipment may be extinguished due to poor
feeding.
※FCC Part l5
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
WARNING：Changes or modifications, to this equipment not expressively approved by the
party responsible for compliance could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
Caution: This Transmitter mustbe installed to provide separation distance of at least 20cm
from all persons.

2. Certification label

3. ExplodedView

4. Single part list
Seq.
NO.
Appellation
Qty
Seq.
NO.
Appellation
Qty
1
Cast iron grill
3
16
Long legs
2
2
Oil guide plate
1
17
Burning chamber handle
1
3
Chimney cover assembly
1
18
Barbecue probe
1
4
Chimney assembly
1
19
Control box assembly
1
5
Chimney insulation cotton
1
20
power cable
1
6
Fire board
1
21
Control box handle assembly
1
7
Furnace assembly
1
22
Control box screen
1
8
Ash tray
1
23
Control box cover
1
9
Frame support plate
2
24
Combustion chamber assembly
1
10
Short leg
2
25
Cover panel
1
11
Shelf
1
26
Upper cover handl e assembl y
1
12
Shelf cover
2
13
6 inch transparent wheel
2
14
axle
2
15
Body floor
1
5. Fixingelements
A B CD
x36 x4 x15 x4
6. Mountingsteps
Make sure your grill is assembled properly. Detailed assembly instructions are packed with
each grill giving specific assembly procedures for each model. Follow these instructions
carefully to ensure the correct and safe assembly of the grill.
Caution: Although we take every effort to ensure that the assembly process is as easy as
possible, it is inherent with fabricated steel parts that corners and edged can cause cuts if
improperly handled during assembly procedures. Be careful while handling any parts
during assembly. It is strongly recommended that you protect hands with a pair of work
gloves.

0.2in
A：8PCS

②
①
A：4PCS

A：4PCS

The screws have been
pre assembled
A：2PCS

B：2PCS
A：8PCS
C：8PCS

A：2PCS
C：2PCS
①
②
The screws have been
pre assembled

B：2PCS
D：4PCS
The screws have been
pre assembled
①
②

A：5PCS
C：5PCS
Please pay attention
to protect the
temperature probe
during installation to
prevent damage
A：3PCS
①
②

7. Use of smokedstove
7.1 Placement of equipment
The smoke oven should be placed in an open and ventilated place, at least as shown in the
surrounding fixed facilities, and away from inflammable and explosive materials.
40" 12"
12"
7.2 Fuel selection
The smoked stove should use standard wood pellet fuel. This kind of fuel can be purchased
in local surrounding stores. Users can purchase fuel of different materials according to
personal preference, but the particle size of fuel should not exceed 1.2”x0.3”. Large fuels
may cause the equipment to go out due to poor feeding.
0.3"MAX
1.2"MAX
7.3 Confirmation before power on
Before powering on the equipment, you should re-confirm the surrounding power
environment, and the socket and plug are not wet or the wiring is bare.
7.4 Button interface

7.5 Ignition instructions
Clean the remaining ash in the combustion chamber before each ignition. Then pour new
fuel into the control box, not to exceed the control box screen (about 2/3), and then put a
small amount of new fuel into the combustion chamber. The fuel is pyramid-shaped to
cover the best layer of the ignition rod 1~2. . Then place the fire plate, the oil guide plate
and the grilling net in turn, close the lid, turn on the Power button, and select the desired
mode.
The device starts to ignite. White smoke will be emitted during the ignition of the fuel, and
personnel can stay away from the operating equipment after waiting for the ignition to
complete.
It should be noted that in order to save electricity, the ignition rod will only work when the
Cook or Smoke mode is selected for the first time after power-on. In other cases, it does not
work. Therefore, if the fuel is not ignited, the power should be turned off first. Key, then turn
the Power button back on and select the appropriate mode to re-ignite.
7.6 Device shutdown
After the barbecue is over, please turn off the equipment safely:
First of all, please open the top cover of the control box, remove the excess fuel from the
box, and keep it for future use.
Then, let the equipment continue to work for 5 to 10 minutes to drain the fuel in the feeder;
Next, click the Power button to turn it off, but don't unplug the power immediately. At this
point, the cooling fan will continue to work for 5 minutes until the fuel is burned out and
extinguished.
Finally, please unplug the power supply and store the oven in a cool, ventilated place,
avoiding sun exposure and heavy rain.
Not exceeding the
filter screen
igniter