Morgan MBL-500W User manual

USER MANUAL
Blender
MBL-500WP
E-mail: [email protected]
www.morgan.my
Market Expansion
Services by
www.dksh.com
facebook.com/morganappliances
MSI-GA221C(IM)150813_Layout 1 8/15/13 12:56 PM Page 1

2
IMPORTANT SAFEGUARDS
7
MSI-GA221C(IM)150813_Layout 1 8/15/13 12:56 PM Page 2
When using the electrical appliance, the below basic safety precautions
should be followed:
1. Read all instructions.
2. Before using check that the voltage power corresponds to the one
shown on the appliance nameplate.
3. Do not let cord hang over edge of table or counter.
4. Do not place on or near a hot gas or electric burner, or in a heated oven.
5. Do not operate any appliance with a damage cord or plug or after the
appliance malfunction or has been damaged in any manner. Return
the appliance to the nearest authorized service facility for examination,
repair or adjustment.
6. If the supply cord is damaged，it must be replaced by the manufacturer
or its service agent or a similarly qualified person in order to avoid a
hazard .
7. Close supervision is necessary when any appliance is used by or near
children.
8. Avoid contacting moving parts.
9. Blades are sharp, so handle carefully.
10. The use of attachment, including jar, jar lid, not recommended or sold
by manufacturer may cause fire, electric shock or injury.
11. The appliance can not be used for blending hard and dry substance,
otherwise the blade could be blunted.
12. Unplug from outlet when not in use, before putting on or taking off parts,
and before cleaning.
13. To protect against risk of electrical shock do not put motor unit or power
cord in water or other liquid.
14. Do not use outdoors.
15. Keep hands and utensils out of container while blending to reduce the
risk of severe injury to persons or damage to the blender. A scraper
may be used but must be used only when the blender is not running.
16. To reduce the risk of injury, never place cutter-assembly blades on
base without jar properly attached.

4 5
MSI-GA221C(IM)150813_Layout 1 8/15/13 12:56 PM Page 3
4
SAVE THESE INSTRUCTIONS
1. Unpack the appliance and place Motor unit on a horizontal surface.
2. Immerse the jar, jar lid and meas uring cup in warm soapy water and
rinse them and dry. Never immerse motor unit in water for cleaning to
prevent the risk of electric shock.
Caution: The blade is very sharp, please handle carefully.
3. The correct assembly way will be
described in detail in below sections.
Before assembling the jar, be sure the
power cord is unplugged from the power
outlet and the speed selector is on the OFF
position.
The blender jar is suitable for making mixture
which the juice and pulp are mixed.
For attaching jar, firstly place the jar lid into the
jar and rotate the jar lid until it is locked into the
groove of the handle tightly (see Fig.1), then
the jar lid is placed tightly and properly with the
jar. And then place the jar into the motor unit
properly and turns the jar in clockwise until it
locks in place (see Fig.2).
Note: Make sure all the assemb ly is placed properly.
BLENDING FRUIT AND VEGETABLE
1. Before assemble or attach the power cord into the outlet, make sure the
speed selector is in the OFF position.
2. Peel or core the fruit or vegetables and then cut it into small dices, put
the food pieces into the jar. Usually certain amount of purified water has
to be added to facilitate the smooth running of appliance. The proportion
of the food and water is 2:3.The amount of mixture should not exceed
the max level as indicated on the jar
Note: Never use boiling liquids or run the appliance empty. The jar can
be used for crushing ice.
3. Place the jar lid in position according to the operation mentioned above
(see Fig.1). And then the safety protection device starts to function.
4. Turn the speed selector to the desired setting. The 1 setting is the
lowest speed and the 2 setting is the highest speed. Repeat to turn
switch to Pulse position and then release it to return the OFF position to
achieve best ice-crush result.
5. You may add ingredients into the jar through the center opening of jar lid
during operation, and then replace measuring cup if necessary. You just
need to press down the measuring cup directly to fix it tightly.
6. The max operation time per time shall less than 3 minutes. Minimum 10
minutes rest time must be maintained between continuous two cycles.
7. Turn the Speed control knob to OFF position once the mixture has been
blended to your desired consistency.
8. Remove the jar from the motor unit (rotate the jar anticlockwise and then
remove it), carefully take off the jar lid, then pour and serve.
KNOW YOUR BLENDER

6 3
MSI-GA221C(IM)150813_Layout 1 8/15/13 12:56 PM Page 4
MAINTENANCE AND CLEANING
The Auto Clean feature can clean the blender and blade assembly
easily and rapidly in complete safety.
-After use, reassemble the jar and pour a little warm water into it and
turn the speed selector to Pulse position for a few seconds to remove
the residual food.
-After stop, remove the jar from the motor unit by turning the jar in
anti-clockwise and rinse the jar under running water.
-Wiping the outer surface of motor unit with a damp cloth, do not
use abrasive cleansers. Never immerse in water or other solution
for cleaning.
-Dry all parts and then replace them.
Warning: Do not use abrasive cleansers. Never immerse in water
for cleaning.
Note: The blade is very sharp, handle carefully when clean.
SPECIFICATIONS
MODEL
RATED VOLTAGE / FREQUENCY 220-240V~ 50/60Hz
RATED WATTAGE 500W
MBL-500WP