Morris HOTEL Series User manual

H OT E L S E R I E S
Instructions manual
Wall mounted hair dryer
Model: H2164HD
Read and save these instructions for future reference

ASSEMBLY AND OPERATING INSTRUCTIONS
Read these instructions thoroughly.
CAUTION
For additional protection, the installation of a residual
current device (RCD) having a rated residual operating
current not exceeding 30mA is advisable in the electrical
circuit supplying the bathroom. Ask your installer
for advice.
Make sure the electrical system is fitted with a device
which guarantees omnipolar disconnection from the
electricity mains under category III overvoltage conditions.
Make sure the unit is perfectly dry before using it.
WARNING: Do not use this appliance near bathtubs,
showers,basins or other vessels containing water.
This hair dryer must be fixed so that a person taking
a bath or shower cannot reach the handle, when the cord
is at maximum extension.
This appliance can be used by children from 8 years of
age and over, and by persons with limited physical,
sensory or mental abilities or who lack the relevant
experience and knowledge, if they are suitably supervised
or have been educated to use the appliance safely and
fully understand the associated risks.

Do not allow children to play with the appliance.
Children must not perform cleaning and maintenance
procedures unless supervised.
Do not use your unit if it is not working properly. Do not
try to repair this electrical unit yourself, rather contact
an authorized technician. If the supply cord is damaged,
it must be replaced by the manufacturer, its service agent
or a similarly qualified person in order to avoid a hazard.
Plug the hair dryer into an alternating current outlet
only, and make sure that the voltage of your electricity
supply is the same as that indicated on the rating plate
of the appliance.
Do not immerse the unit in water or other liquids.
Never put the appliance in a place where it could fall
into water or in other liquids.
Do not try to salvage an electrical appliance which has
fallen into water.
Turn the unit off when you put it down.
Unplug the appliance when not in use, but never do it
by pulling the cord.
Remember to check regularly that the air inlet and
outlet grills are clean.

Allow your appliance to cool before storing away
and do not wrap the supply cord around the hair dryer
in storage.
INSTALLATION INSTRUCTIONS
This is a model with universal shaver socket and hair dryer
on/off switch. A safety transformer insulates the shaver
socket from the mains and a protection device inhibits the
operation of the appliance with a load higher than 20VA.
Installation of wall holder
This work should only be carried out by a suitably
qualified electrical engineer, in order to comply with the
existing national safety regulations. The hair dryer should be
positioned in a place where it could not be reached by a
person using the bath or the shower when the spiral cord
is extended to its maximum length.
Attention: before installing the hair dryer always
switch off the general switch of your mains electricity.
1. Separate the cover (1) of the wall holder from the back
plate by loosening the screw (2) according to picture 1.
2. Drill four holes with 6mm’diameter according to
picture 2.

1
2
picture 1
picture 2
3.Put the toggle inside the holes, place the base onto
the wall and secure with the screws.
4. Secure the front cover with the screw (2).
5. Switch on the general switch of your mains electricity.
The hair dryer is ready for use.

INSTRUCTIONS FOR USE
Control Switches
Control switch on wall holder 0-1 = Off/On
Hairdryer
Pushbutton:
ON=On/Off (pressure must be maintained to operate the
hairdryer)
C = Low air speed
1 = Medium air speed
2 = High air speed
PRODUCT CARE
When not in use, the mains switch on the wall holder
should be in the “Off” position.
You can clean your appliance with a cloth dampened
with water.
The cleaning of hair dryers with detergents, solvents,
alcohol and other chemical products is strictly prohibited.
When necessary, the air inlet grill should be cleaned with
a soft brush or a vacuum cleaner.

NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality
materials and components which can be recycled and reused. This
symbol means that electrical and electronic equipment, at their end-
of-life, should be disposed of separately from your household
waste. Please dispose of this equipment at your local community
waste collection/ recycling centre.
In the European Union there are separate collection systems for used electrical
and electronic products.
Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
Herewith, Amiridis-Savvidis S.A. states that this product, complies with the
requirements of below directives:
EMC-Directive: 14 / 30 / EU
Low Voltage Directive: 14/ 35 / EU
CE Marking: 93 / 68 / EEC
RoHS Directive: 11 / 65 / EU & 15 / 863 / EU
The detailed declaration of conformity can be found at www.morris.gr
Exclusive importer in Greece:
Amiridis – Savvidis S.A.
87A, 17th Noemvriou str, P.C. 55534
Thessaloniki – Greece
T: [phone] | F: [phone]
www.amiridis-savvidis.gr