Moss WASHPARK User manual

WASHPARK
DESK
Screwdriver
Slotted Screwdriver
Mallet or Hammer
Tool Required:
Tool Provided:
T1 M4 Hex wrench x 1
H1 Wooden Dowel
(8x35mm) x 4
H2 Steel Dowel
(52mm) x 4
H3 Set screw x 4
H4 Barrel Housing x 4
H5 Allen Head Bolt
(M6x30mm) x 10
C1 Desk Top x 1
C2 Modesty Panel x 1
C4 Right Leg x 1
C3 Left Leg x 1
Placement and Maintenance
Your WashPark Desk is designed for indoor use on level
floors. Furniture with hard lacquer, wax polish or painted
surface should be dusted with a dry cloth. Spillages should
be wiped up as soon as possible. Our furniture will endure
most temperatures in the home but it is best to avoid placing
furniture next to heat sources such as radiators or fires.
Step 1
Unpack and identify the parts listed below. The assembly
workspace should be a non-marring surface such as carpet.
For missing hardware pieces, visit the customer support
page on our website www.mossdesign.us

H1 Wooden Dowel
(8x35mm) x 4
H3H4
Slotted Screwdriver
Step 2 - Assemble barrel housing.
Using a slotted screwdriver, partially thread 4 set screws H3 into the 4 barrel housings H4.
DO NOT thread more than a few clockwise turns!
Step 3 - Attach dowels to Modesty Panel.
Fix 4x wooden dowels H1 to modesty panel C2 by using a mallet.
C2
H1

Step 4 - Attach hardware to legs.
Using either a slotted or screwdriver, thread 4 steel dowels H2 into the threaded inserts on the 2 leg
frames as shown.
Step 5 - Left leg to desk top.
Bring the left leg C3 closer to the desk top C1 and insert the 5 allen head bolts H5 into the slots, tighten the
bolt using the hex wrench T1 as shown below.
C3
C4
H2
C3
C1
H5
T1

Step 7 - Attach right leg to desk top.
Place the 2 barrel housings H4 on the modesty panel, put the steel dowels into place as shown below.
Step 6 - Fix the modesty panel.
Place the 2 barrel housings H4 on the modesty panel C2 , put the modesty panel on its final position
tighten the set screws by using a screwdriver as shown below.

Step 9 - Fix the modesty panel.
Tighten the barrel housing H4 in the modesty panel C2 by using a screwdriver.
Step 8 - Fix the right leg.
Insert the 5 allen head bolts H5 into the slots as shown below and tighten by using a hex wrench T1.
T1
H5

Step 10 - End of the assembly.
Lift the unit to standing position carefully.
Top panel max loading capacity 88 Ib
Drawer max loading capacity 15 lb
Moss Design is a trade name of a Colorado company Moss Furniture LLC
www.mossdesign.us