Motorola TN20 - MOTONAV - Automotive GPS Receiver User manual

1
welcome
The MOTONAV™ TN20 helps you find the best route with GPS accuracy.
Clear turn-by-turn directions and spoken street names eliminate second-
guessing when making a turn. Locate your favorite restaurant, nearest bank,
or see businesses and other locations along your route. Save time and gas,
and leave getting lost to the past. The MOTONAV TN20 includes:
 •Turn-by-turnnavigationwith2Dand3Ddisplaymodes
 •Clearspokenstreetnamesanddirections
 •Businessesandotherlistingsshownonmap
 •SDmemorycardslotforaddingadditionalmaps
Note:Beforeusingyourdeviceforthersttime,besuretoreviewthe
important safety and legal pamphlet and follow instructions. Periodically
review this information so you remember how to safely use your device.

2
3
before you begin
Take a moment to familiarize yourself with the components of your
MOTONAV TN20.
Power button (on side)
indicator
light
memory
card
slot (on
side)
charger
port
speaker (on
reverse side)
touch display
screen
Reset
button
(on side)
Warning: Traffic laws and current traffic conditions must always be observed and
take precedence over the instructions issued by the navigation system. The user
should be aware of situations where current traffic conditions and the instructions
from the navigation system may be in conflict.
The use of the navigation system does not relieve the user of his/her responsibilities.
The user is ultimately responsible for the vehicle under his/her control and should be
aware of the surroundings at all times. For traffic safety reasons, it is recommended
that routes should be planned in a stationary vehicle before starting a trip.
MOTOROLA IS NOT RESPONSIBLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, EXEMPLARY, SPECIAL, OR PUNITIVE DAMAGES, OR OTHER
DAMAGE ARISING OUT OF THE USE OF, OR INABILITY TO USE, THIS PRODUCT. THIS
INCLUDES DAMAGE TO PROPERTY AND, TO THE EXTENT PERMITTED BY LAW,
DAMAGES FOR PERSONAL INJURY AND DEATH.
Laws in some areas prohibit the use of a cellular phone and other devices when
driving a motor vehicle. Please use the utmost care in using your devices safely under
all circumstances. It is the responsibility of each user to be aware of and abide by any
and all local laws and ordinances, which may restrict the use of cellular phones and
other devices.
Your local law may prohibit attaching the Navigation Device to the windshield. In such
case, attach the mount to the enclosed plastic disk and adhere it securely to a clean,
smooth surface of your car. Never position the device in a manner which blocks your
view of the road, interferes with the safe operation of the vehicle (e.g. do not place on
the steering wheel or in front of an air bag), or could otherwise result in injury to the
user. Always obey local laws and restrictions concerning use of such products.

4
5
mount it
Note: You can also affix suction cup to the dashboard using the included
circular disc (not shown). To do this, affix circular disc to your dash or center
console, then attach the suction cup on the extension arm to the disc.
3Place your MOTONAV TN20 in the holder.
4Using both hands, adjust extension arm for optimal viewing on your
MOTONAV TN20.
mount it
You can safety secure your MOTONAV TN20 in your car using the included
mounting holder.
1Slide holder down onto the extension arm.
2Affix suction cup on extension arm to the windshield (push up on lever).

6
7
power it
Note: Your battery is designed to last the life of the product. It should only
be removed by a recycling facility. ANY ATTEMPT TO REMOVE OR REPLACE
YOURBATTERYWILLDAMAGETHEPRODUCT.
For more details on powering and charging your MOTONAV TN20, see
“power and charging” on page 15.
power it
Once mounted, apply power to your MOTONAV TN20 using the included
car charger.
1Plug the charger into the power outlet in your vehicle.
2 PlugthechargerintotheUSBportonyourdevice.
Whenpluggedintoacharger,theindicatorlightisorangetoindicatethe
device’sinternalbatteryischarging.Whenfullycharged,theindicatorlight
turns green.

8
9
get started
7Verify that the device displays your current location on the map view
screen like shown below.
If you see FindingYour GPS Location at bottom of the screen, the
MOTONAV TN20 is searching for GPS satellites. Move device to an open
location with a clear view of the sky and wait a few minutes to obtain
satelliteGPSsignal.Whenobtained,yourcurrentlocationappearsonthe
map view screen.
Initial configuration of your MOTONAV TN20 is now complete!
get started
To get started, you need to turn on your MOTONAV TN20 and configure
initial device settings:
1Press and hold Power button to turn on the device until the display
becomes active.
After a few moments, a configuration wizard appears to provide
step-by-step setup instructions.
2Set your language preference and tap OK.
3 ReviewWarningmessageandtapOK.
4Review End User License Agreement (EULA), then tap I Agree checkbox
and OK.
5Set your time zone settings and tap OK.
6Set your preferred measurement units and tap OK.

10
11
find an address
To create a route to an address:
1From the map view screen, tap Menu button to access
the main menu screen.
2Tap Go!.
3Tap Address. You see:
Note: To change state of destination, tap Change and select new state.
4Tap the Address button.
5Enter the town/city and tap OK.
6Enter the street and tap OK.
7Enter the address number and tap OK.
8Tap Go.
A route is calculated to your selected address.
The map view screen provides your main view when driving to your
destination. Tap the screen icons to control the map view and perform
other tasks.
use map view screen
2
3
4
5
6
1
7
1zoom map in and out
2display main menu
3changemapview(2Dor3D)
4change/mute volume
5heading indicator
6current street
7battery charge indicator

12
13
find a destination
To search for and create a route to a business or other point of interest:
1From the map view screen, tap Menu to access the main menu screen.
2Tap Go!.
3Tap Food, Fuel, Lodging and More. You see:
4 Tap My Current Location to search near your current location.
5Tap desired destination type (or tap Spell Place to search by name).
6 Select the category and tap OK.
7Select the destination and tap OK.
8Tap Go.
A route is calculated to your selected destination.
use route screen
Once you’ve mapped your route, the map view screen displays your route
details.
Tap the route status bar to switch between viewing:
 •traveldistance,timeremaining,andestimatedtimeofarrival,
 •currentstreetname,or
 •currentspeedandaltitude.
Tap the next street bar to perform route management tasks such as:
 •showdrivingdirections,
 •viewroutemapoverview,or
 •cancelroute.
Tap the next turn icon to repeat audio turn instructions.
next
turn
route status bar
current
location
next
street
bar
route
lane information

14
15
tips & tricks
 •Tochoosetheitems(buttons,bars,icons)displayedonthemapview
screen, go to Map in the Settings screen from the main menu.
 •Tochoosecategoriesoflocationstodisplayonthemap,goto
Map Icons in the Settings screen from the main menu.
 •Toenable/displayspecicvoicepromptsandsounds,gotoPrompts
in the Settings screen from the main menu.
 •Tobrowsemap,gotoFree Map Browsing in the Settings screen
from the main menu. Tap the map to select a location.
 •ToresettheMOTONAV TN20, press the Power button for 8 seconds,
then press Power button again to turn on. You can also use a pin to
press the Reset button.
 •Whencreatingaroutetoanaddress,afterselectingthecity,youcan
choose to go to the center of the city (versus an address) by selecting
the “City Center” destination.
power and charging
Your MOTONAV TN20 should be powered using the included car charger.
Whenyoudisconnectthepoweradapter(orturnvehicleignitionoff),it
prompts you to touch the screen to switch to battery power. If you do not
touchthescreen,itwillturnoffafter30seconds.
Please note the following:
 •IfpoweringdownyourMOTONAV TN20 using the Power button, it must
also be powered on using the Power button.
 •IfyourMOTONAV TN20 turns off after disconnecting the external power
source, it turns back on when external power is restored or if you use
Power button.
 •IfyourMOTONAV TN20 is not used for more than 7 days, it enters a
power saving mode that requires a Power button press to exit.
 •Whenoperatingonbatterypower,theindicatorlightashesredwhen
the battery is low.
 •UsinganotherchargertochargeyourMOTONAV TN20 may not be as
effective.
 •TheincludedcarchargerwillnotpowerMotorolaphones.

16
Motorola, Inc.
Consumer Advocacy Office
1307 East Algonquin Road
Schaumburg, IL 60196
www.motorola.com
www.motorola.com/motonav
1-800-331-6456 (United States)
1-888-390-6456 (TTY/TDD United States for hearing impaired)
1-800-461-4575 (Canada)
The use of wireless devices and their accessories may be prohibited or restricted in
certain areas. Always obey the laws and regulations on the use of these products.
All features, functionality, and other product specifications, as well as the information
contained in this user’s guide are based upon the latest available information and are
believed to be accurate at the time of printing. Motorola reserves the right to change
or modify any information or specifications without notice or obligation.
MOTOROLA and the Stylized M Logo are registered in the US Patent & Trademark
Office. All other product and service names are the property of their respective
owners.
© 2008 Destinator is a registered trademark of Intrinsyc Software International, Inc.
Unauthorized duplication is a violation of all applicable laws. Other names and brands
mentioned herein may be the property of their respective owners. Patents pending.
Map data: © 1993 – 2007 NAVTEQ. All rights reserved
Manual Number: 68000201204-A
© 2008 Motorola, Inc. All rights reserved.