MOVETEC MCP-TDH6 User manual

Version : E
ReleaseDate :08/16/2017
MCP-TDH6 User Guide

Version : E
ReleaseDate :08/16/2017
Dimensions
User InterfaceGuide
A. Height Adjustment Buttons
B. Memory Position Buttons
C. Memory Setting Button
D. Digital Display

Version : E
ReleaseDate :08/16/2017
Power SavingFunction -Waking uptheControl
 When no button has been pressed for 10 seconds, display goes off. Press any button to light up the display again.
 When no button has been pressedfor30 seconds, the system goesto <0.1W standby mode. Long press any button
to wake the system up. Display shows desk height again.
Adjusting theHeight
Press ▲or ▼to adjust theheight.
Reset
Simultaneously press ▲and ▼for 3 seconds. Continue pressing the buttons until both columns are in
lowest position. When finish reset, the control box makes a beep and the buttons can be released.
 When conducting reset, the display shows “000” in last 100mm stroke. When finish reset, the display shows
starting height again.
Ifreleasing ▲and ▼buttons before the display shows“000”,thedeskgoes backto normal operation. If
releasing ▲and ▼buttons after the display shows “000”,the user has tofinish the reset to go back to
normal operation.

Version : E
ReleaseDate :08/16/2017
 Reset is necessary at first operation of the desk and when the desk legs aren’t moving synchronously.
Presetting the Desk Starting Height
The default starting height is 65cm.
To adjust the starting height, press ▼button to go to the lowest position of the desk. At the lowest position,
continue pressing ▼ button for 5 seconds, display stars flashing for 10 seconds (enter the settingmode)
During the 10 seconds, press ▲or ▼buttons toadjust the starting height tothe desired height. After 10
seconds, the display stiops flashing and the preferred starting height is shown and has beenstored.
Memorize position
 Adjust the desk to the desired height, then press “ S” for 3-5 seconds. The digital display will flash for 5 seconds.

Version : E
ReleaseDate :08/16/2017
Press 1or 2or 3or 4to assign the desk's position to the respective button.
o*Note:Ifyoudon'tfinishthisprocedurewithin5seconds,theTDH6willlogoutmemorysetting mode
automatically.
Press and hold button 1 or 2 or 3 or 4 to move the desk to memory position.
Stored position can only be overwritten, not to be cleared.
Error Codes
The digital display shows the error codes below to suggest the issues that users may encounter during the operation.
(Note 4)