4. The volume knob controls the volume of the right side
speaker sounds only. You can adjust the volume, while
operating the speed up/down buttons to emulate the
sounds approaching or fading away.
5. All sounds associated with the sound push buttons can
be re-triggered. You can repeat the same sound before
the sound ends to make it seem longer. Or you can start
a new sound to cut off the current sound.
6. You can play one sound from each group at the same
time.
7. Only one slide switch sound can be activated at one
time, (right side position). The unit may not operate
properly if more than one slide switch is activated.
8. The mode switch, speed up/down buttons and the
volume control knob operate independently of the sound
buttons, and do not interfere with the playing of the
sounds.
9. There are numerous choices for either the diesel horn
or the steam whistle. Use the select button for that group
to change the sound of the horn/whistle to the one you
prefer. The current horn/whistle selected will play first,
and then keep pressing the select button to find the one
you like. Then every time you press either the horn or
whistle button, the one you selected will play.
10. The diesel horn or the steam whistle will always be
ready to play regardless of which mode you are in.
11. Just activating the rail clack slide switch will not make it
play. It is synchronized to the speed of the locomotive,
(either mode). Of course if the locomotive is at idle,
there are no rolling wheels clacking over rail joints.
12. There are also two types of coupling sounds. If you do
not like the one playing you can change it to the other.
2