Mueller Groin Trimmer Pro User manual

Groin Trimmer Pro
USER MANUAL
Model BW-1200

Your satisfaction is guaranteed. If you are not
completely satisfied with our Groin Trimmer Pro
and the results it brings, we insist that you let us
know. We’ll help make the trimmer work for you,
or we’ll refund your money.
- Do not handle the power cable and charge
the trimmer when hands are wet.
- Do not pull hard on the power cable. It can
damage the cable, cause a power leakage,
short circuit, or re. If damaged, stop using
immediately.
- Keep this product out of reach of children to
prevent injury and avoid further danger.
- Only use the original power cable and acces-
sories provided by the manufacturer to avoid
possible damage to the product or user.
- This product is suitable only for trimming
hair, do not use it for any other purpose.
IMPORTANT SAFEGUARDS
11

MEET YOUR GROIN TRIMMER PRO
Lubricating
oil Cleaning brush USB cable
On/Off switch
Standard
trimmer head
Narrow
trimmer head
Guide comb
3-6mm Guide comb 9-12mm Guide comb 2mm
2
Indicator light

TECHNICAL SPECIFICATIONS:
Rated power: DC 5V 1A
Battery: Ni-MH 600mAh
Charging time: 5 hours
Usage time: Approx 50 minutes
Safely Exchangeable Trimmer Heads -
Equipped with 3 guide combs for trimming
hair of various lengths.
R-shaped round corner on the Standard
trimmer head prevents scratching of the skin.
100% Waterproof - Safe to use in the shower,
and easily cleaned under running water.
TECHNICAL HIGHLIGHTS:
3

USING YOUR GROIN MASTER PRO
NOTE: The blades may slightly heat up during
usage. This is normal and will not aect the
performance of the blades or safe use.
ATTENTION! When disassembling, hold the
trimmer upright and remove the trimmer
head in an upward motion to prevent hitting
any nearby objects. The Standard Trimmer
Head white ceramic blade is fragile and
should be handled with care!
To ATTACH the trimmer
head, align the guideline
engraved on the trimmer
head with the guideline on
the body, and press the head
downwards until you hear a
click.
To DETACH, simply pull the
trimmer head away from the
body in the opposite direc-
tion.
ATTACHING AND
REMOVING TRIMMER
HEAD:
ATTACHING AND REMOVING GUIDE
COMBS:
NOTE: Guide combs are used to cut hair at
xed lengths to avoid cutting too much hair
by mistake, especially during initial use, while
you get used to the product.
4

Comb adjustment:
Adjust the comb length by sliding the comb
slightly forward or backward between notch-
es to desired length (9-12mm).
(9mm position)
(12mm position).
Similarly, the same
method applies for
the 3-6mm guide
comb.
To remove the guide
comb, simply push
forward from the
bottom of the comb
and slide o the
trimmer head.
To attach the guide comb to the Standard
Trimmer Head, slide the comb over the
trimmer with comb notches sliding into the
grooves on the sides of the trimmer head.
STANDARD TRIMMER HEAD:
5

To attach the guide comb to the narrow
trimmer head, align the slot on one side rst
and then the other and push the comb on
until it clicks into place.
To detach the guide comb from the trimmer
head, simply push up one side of the comb
and pull up to remove it o the trimmer
head.
NARROW TRIMMER HEAD:
6

CLEANING & MAINTENANCE
CLEANING:
Turn OFF the trimmer.
Remove the guide comb and trimmer
head from the main body. Using the cleaning
brush, brush o the hair from the comb,
trimmer head, and rest of the trimmer body.
ATTENTION! Do not use gasoline, alcohol, or
other corrosive chemical agents.
NOTE: Only the Standard Trimmer Head can
be disassembled for cleaning purposes.
DISASSEMBLING, CLEANING, AND ASSEM-
BLING OF STANDARD TRIMMING HEAD:
- Hold the Standard Trimmer Head rmly
with one hand, and push the blade down-
ward to detach.
- Press lightly on the spring to separate the
upper and lower blade, then brush with a
cleaning brush. If you are cleaning with
water, dry thoroughly to avoid rusting of the
springs.
2
1
7

- After you are done cleaning, align the nodes
at the bottom of the blades with the two
slots engraved within the Standard Trimmer
Head, then press the top of the blade rmly
until the blade snaps into place.
ATTENTION! Never take o the springs of
the trimmer head blades; otherwise, the
blades may not return to their correct
position within the trimmer head for normal
operation.
8