munisense NP2 User manual

for more information, see:
munisense.com/support
NP2 Quickstart Guide
NP2 QuickStart Guide 1v0 Page 1 of 3
Contents of the box
•NP2 meter
•230V adapter
•Weather protector and windscreen
•Pole mountingplate
First use instructions
1. Unscrew the four screws on the lid of the NP2 and take the lid off.

for more information, see:
munisense.com/support
NP2 Quickstart Guide
NP2 QuickStart Guide 1v0 Page 2 of 3
2. Optional: if necessary, insert SIM card in the SIM card slot. Ensure that the battery switch is off
and the powercable is NOT connected.
3. Flip the “Battery” switch the “ON” position. The LED indicators on the side should show activity
now.
4. Screw the lid back on. Attach the mounting plate and place the gateway on the required
location with the antenna facing down. Connect the 24v power supply, battery pack or a
solar panel. An empty NP2 will charge in 4 hours to around 90%.
LED Indicators
Network Uplink LED
GREEN: HSPA / LTE modem connection in use
ORANGE: Ethernet connection in use
1/8s blink: internet connection established
1/4s blink: connection to backoffice made
1/2s blink: backoffice services reachable
continuous: data is flowing to the backoffice
Sensor Network LED
GREEN: sensor network up and receiving data
ORANGE: sensor network up
RED: sensor network down

for more information, see:
munisense.com/support
NP2 Quickstart Guide
NP2 QuickStart Guide 1v0 Page 3 of 3
Power LED
GREEN: battery charging (mains high enough to charge)
ORANGE: battery not charging (mains too low to charge)
+
1/4s blink: battery nearly empty
3/4s blink: sufficient battery charge available
continuous: battery full
RED: battery fault or empty battery on start-up
RED/GREEN blinking: The battery switch is in the off position (it will still charge)
OFF: Will switch automatically off after 5 minutes (battery full)
On start-up a flashing RED LED indicates charging. The gateway will boot when the battery
has enough charge. Note: for an empty battery this will take around 20 minutes.
The power LED indicator will turn off 5 minutes after the gateway starts.