Assembly Instructions for UR3600
Assembly Instructions for UR3600
Assembly Instructions for UR3600
IMPORTANT NOTE : Make sure all rivets are fully seated into the post slots.
IMPORTANT NOTE : Make sure all rivets are fully seated into the post slots.
IMPORTANT NOTE : Make sure all rivets are fully seated into the post slots.
Add side panels to the sides of the unit by inserting the
tabs of the panels into the slots of the post. Push the
panels down so the tabs fully engage into the post slots
(see figure E). Assemble the back panels together by
inserting the tabs from one panel into the slot holes of
the other so that the two panels overlap and lock to-
gether (see figure F). Install the back panels to the unit
by following the same procedure for the side panels
(see figure G).
Step
2
Step
3
Step
4
Figure D
Slots 13 & 14 Laminate shelves
Figure G
Laminate shelves
Doors
Hinges of door
fasten to post
slots six (6)
& twenty (20)
from bottom.
Figure H
Assemble two (2) post with one (1) brace. Skipping one
slot from the bottom of the post (see figures A & B),
place the rivets into post with the slot pointing down,
and with the shelf ledge of the brace facing up, and tap
lightly to seat rivets (see figure A). Repeat with two (2)
post and one (1) brace. Assemble the two (2) post end
units with one (1) beam for the back, and one (1) beam
for the front (see figure C). Skip one hole from the bot-
tom of post, tap lightly to seat rivets.
Step
1
Figure A
Shelf Ledge
Post
Tap Lightly
Note:
Post are
directional.
The slot
must point
down.
Post Slot Points Down
Figure C
Beam
(Front)
Skip One (1) Slot
Figure B
Brace
Top
Post
Tap Lightly
Slot
Down
Bottom
Post
Final levels
of beams &
braces.
Beam
(Back)
Beams
(Front)
Beams
(Back)
Add a laminate shelf to the level previously built, then add
the second level using two (2) beams, and two (2) braces
in post slots thirteen (13), and fourteen (14) counting up
from the bottom. Add the laminate shelf. Assemble the
top post to the bottom post by using two (2) beams, and
the two (2) braces. One (1) rivet from each beam and
brace must be placed in the top hole of the bottom post,
and the bottom hole of the top post (see figure D).
Note:
Post are
directional.
The slot
must point
down.
Slide part
Slide part
Figure F
Back Panels
Door
handles
Back Assembly
Figure E
Side Panel
Tab fully inserted
to slot of post
Add a laminate shelf to the level previously built. Using the
last of the beams and braces, add the final two (2) levels to
the unit. Add laminate shelves to the levels built, then align
hinges of the doors to the sixth and twentieth post slots from
the bottom. Fasten hinges to the post using one (1) per
hinge of the #1/4-20 x 1/2” hardware provided. Insert the
door handles into the cutout holes of the doors. Push the
handles into the holes until it snaps into place (see figure H).
Install the magnets to the inside of the doors. Optional an-
chor hardware is supplied with this unit so the unit can be
fastened to a wall if necessary.
