MV Sports & Leisure Kickmaster Pro-lite Goal User manual

Pro-lite Goal
Please retain this leaflet for reference to the
manufacturer
Carefully made in China to European
Safety Standard
CUSTOMER HELPLINE
We make every effort to ensure that this product
reaches you in satisfactory condition.
However if you have any queries, need
assistance, or find this product defective,
please call our Customer Helpline:
0870 8404255 UK ONLY)
MV SPORTS & LEISURE LTD
35 Tameside Drive • Castle Bromwich
Birmingham • B35 7AG • UK
Email: [email protected]
www.mvsports.com
DISTRIBUTED BY
Product No. M06042
PLEASE READ BEFORE ASSEMBLY
03.03 - ISSUE 1
CONTENTS:
WARNINGS
To be assembled & dismantled by an adult.
To be used on a flat surface.
Check the frame assembly is securely
located before use.
Ensure frame is securely pegged to ground
before use.
Do not leave outdoors in adverse weather
conditions.
Do not climb or hang from the structure.
Check regularly for wear and tear.
discontinue use if any breakage is found.
failure to do this may result in injury.
Keep away from fire.
Keep away from heat sources.
THIS PRODUCT IS NOT SUITABLE FOR
CHILDREN UNDER 3 YEARS
DUE TO SMALL PARTS
1. Net support tubes x4)
2. Straight connectors x6)
3. Elbow connectors x6)
4. Net support tube connectors x2)
5. Tube fasteners x24)
6. Net securing clips x30)
7. Metal pegs x4)
8. Plugs x2)
NOTE: WHEN JOINING TUBES TO
CONNECTORS ALWAYS ENSURE
THAT THE HOLES IN THE TUBES
ALIGN PROPERLY WITH THE HOLES
IN THE CONNECTORS BEFORE
SECURING WITH TUBE FASTENERS.
1. Connect the frame tubes with letters
together, as illustrated.
2. Apply tube fasteners 5) to each
tube connection point, as illustrated.
NOTE: Fastene s lock afte one
qua te tu n.
3. Fit the plugs 8) into the bottom front
elbow joints
6
8
7
5
2
4
3
AAA
C
C
D
D
B
B
B
E
F
8
5
Ax3)
B x3)
C x2)
D x2)
E x1)
F x1)
1
Please ensure
tube fasteners are only turned a quarter turn.

4. Join the net support tubes tubes 1) in two
pairs, using the net support tube connectors
4), as illustrated.
5. Fit each net support tube assembly by inserting one
end into the hole in the elbow on the back cross bar.
Carefully bend the tube towards the top cross bar and
insert into the hole in the elbow. Make sure that the
tube is pushed fully home into the elbows.
6. Apply Kickmaster
sticker before attaching
the net to the frame.
7. Spread the net over
the goal assembly
and fasten in place
using the net
securing clips 6).
Suggested
pegging points
Kickmaste sticke
4
6
1
Thicker section
on outside of
bend
Secu ing F ame
Fix the frame to the ground using 4 pegs 7). Position around the frame base as illustrated.
Secure pegs using a mallet.
CAUTION: Check regularly that pegs are secure. Loose pegs may cause injury.
Care should be taken when using a mallet as misuse may cause injury.
CAUTION: When assembled the goal is under tension.
Extreme care must be take when disassembling.
Check frame regularly to ensure tube frame toggles and net ties are secure.