MV Sports & Leisure Kickmaster Target Shot User manual

Target Shot
Please retain this leaflet for reference to the
manufacturer
Carefully made in China to European Safety
Standard
CUSTOMER HELPLINE
We make every effort to ensure that this
product reaches you in satisfactory condition.
However if you have any queries, need
assistance, or find this product defective,
please call our Customer Helpline:
0870 8404255 UK ONLY)
MV SPORTS & LEISURE LTD
35 Tameside Drive • Castle Bromwich
Birmingham • B35 7AG • UK
Email: [email protected]
www.mvsports.com
DISTRIBUTED BY
Product No. M06016
PLEASE READ BEFORE ASSEMBLY
03.02 - ISSUE 3
CONTENTS:
FRAME ASSEMBLY
Before assembling the frame it is necessary to slide the target hooks
over the frame tubes. You will need to slide 6 target hooks over no.3
tube top tube and 3 target hooks over each no.4 side tubes.
Being careful to select the appropriately numbered tubes, assemble
the frame as illustrated.
WARNINGS
To be assembled & dismantled by
an adult.
To be used on a flat surface.
Check all wing nuts are firmly tight
and the frame assembly is
securely located before use.
Ensure frame is securely pegged
to ground before use.
Do not leave outdoors in adverse
weather conditions.
Do not climb or hang from cross
bar.
Check regularly for wear and tear.
discontinue use if any breakage is
found. failure to do this may result
in injury.
Keep away from fire.
Keep away from heat sources.
THIS PRODUCT IS NOT SUITABLE
FOR CHILDREN UNDER 3 YEARS
DUE TO SMALL PARTS
Tube no.1 & 2 x4)
Tube no.3 x2)
Tube no.4 x2)
Tube no.5 x2)
Tube no.6 x2)
Tube no.7 x2)
Tube no.8 x2)
1 Target hook x12)
2 Bolt x4)
3 Washer x4)
4 Wingnut x4)
5 Elastic target ties x6)
6 Net ties x35)
7 Target
8 Net
9 Target peg x6)
10 Frame peg x16)
Tube no.3
Tube no.1 & 2
Tube no.6
Tube no.
Tube no.4
Tube no.8
Tube no.7
1
2
3
4
6
10
9
8
7
3
3
11
8
4
62
2
6
4
7
7
8

TARGET ASSEMBLY
Space out the target hooks to match the eyelets in the target. Hook the target into position.
NET ASSEMBLY
Spread net out, locate the two red tabs. Put the net over the frame with the red tabs in the top left and right hand
corners of the frame. The seam of the net should follow the frame supports. Secure using net ties ensuring you
space them out evenly over the whole frame.
SECURING THE FRAME AND TARGET
When the frame, target and net are assembled the target and frame need to be secured to the ground.
Position the target shot assembly in a suitable postion see warnings).
Securing Target
Fix the target to the ground by threading the
elastic loops through the bottom eyelets and
fasten to the ground with small pegs. Secure
pegs using a mallet. Ensure the pegs are pushed
fully into the ground at an angle, as illustrated.
Red Tab
Suggested frame
pegging points
Securing Frame
Fix the frame to the ground using 16 large pegs.
Position around the frame base as illustrated.
NOTE: To secure frame firmly to ground always
anchor two pegs together as shown) at anchor
points indicated. Secure pegs using a mallet.
CAUTION: Check regularly that pegs are secure.
Loose pegs may cause injury.
Care should be taken when using a mallet as
misuse may cause injury.