myappliances SPLASHBACK User manual

GB IE
SPLASHBACK
USER MANUAL

GB IE
Let's
get started...
Getting started... 04
Before you start 05
Safety 06
In more detail... 07
Care and maintenance 08
Appendix
09
Installation

3
Getting
Started...
Getting started...
GB IE
Before you start 05
Safety 06

Before you start
Before you start
Check the pack and make sure that you have all parts listed.
When you are ready to start, make sure that you have the
right tools available, plenty of space and a clean dry and
smooth area for installation.
After unpacking the appliance please check that it is not
damaged. If in doubt, do not use the appliance but contact
Customer Services on 0844 800 1128 (UK), 1 800 535542
(Ireland) and 01 56 48 02 60 (France)
You will need
SILICONE
4
Getting started...
GB IE

CAUTION: Always ensure the product is securely installed
before use.
Self adhesive tape is a xation support until the silicone
sealant has set
Domestic use only
If this product contains glass, please take care when tting
or handling to prevent personal injury or damage
The hob must not be used for 24 hours after the splashback
has been installed
Wait 24 hours before removing the protective lm
Safety
5
Getting started...
GB IE

6
In more detail...
In more
detail...
GB IE
Care and maintenance
08

Care and maintenance
Care and maintenance
• Clean Stainless Steel using non-corrosive, liquid detergent or
a special stainless steel cleaner and avoid the use of abrasive
cleaning products.
• Clean glass with a damp cloth and mild soap. Dry with a soft
clean cloth. Never use scourers, abrasives or chemical cleaners.
7
In more detail...
GB IE

8
Installation
Appendix...
Appendix...
GB IE

01
9
Installation
NOTE: Ensure walls are level and clean.

10
SILICONE
NOTE: The double sided tape supports the splash back while the silicone adhesive sets.
Glass
Stainless Steel
SILICONE
SILICONE

03
11
Note for Glass splashbacks:
If installing the glass splash back, then a 2mm gap needs to be left all the way around, so it can expand without
pressing against anything which will cause internal stresses.
Note for S/Steel splashbacks:
WARNING: The hob must not be used for 24 hours
after the splashback has been installed.
WARNING: Wait 24 hours before removing the
protective film (only on s/steel version)
2 mm
SPLASHBACK
WORK SURFACE
[01]
Seal around the Splash Back with silicone sealant.

GB IE
MYAPPLIANCES
Unit 3 Normandy Landings,
3 Pope Street
NORMANTON
West Yorkshire
WF6 2AG