Myzone Inbody 570 Manual

Inbody 570 Raspberry Pi Setup Instructions
STEP 1: Please check that you’ve received all of the following.
Raspberry Pi Power Adaptor
Gender Changer
USB to Null
Modem Adapter
1 2
4
3
STEP 2: Connect USB to Null Modem Adapter
to Gender Changer as shown
STEP 3: Connect USB-Serial Cable to USB Port of
Raspberry Pi (as seen here).
myzone.org | 1
EFFORT REWARDED.

| Inbody 570 Raspberry Pi Setup Instructions
STEP 4: Connect other end of connected cable run
(Gender Changer) to port on back of scales.
STEP 5: Connect network cable to Raspberry Pi.
myzone.org | 2
STEP 6: Connect Power Adaptor to mains and to
Raspberry Pi.

myzone.org | 3
STEP 7: Now that the
hardware is connected you will
need to congure the scales.
On the scales screen press
Administrator Menu.
STEP 10: Press the right hand
corner 5 times to access secret
menu options
Now Click Exit to get back to home screen. Setup is now complete and
the scales are ready to use.
STEP 8: Enter Administrator
Password (0000) and press
Enter
STEP 11: Press the circle to
enable Open protocol
STEP 9: Press arrow to
navigate to 2nd page.
STEP 12: Press the Blue
‘Save’ Button
| Inbody 570 Raspberry Pi Setup Instructions