
Model Code NKC-180
Suitable tool
Ø175~180mm (7 inch class) / h20-30mm Diamond Grinding Cup Wheel
Weight 0.8kg (Main Unit with adaptor system)
Material Concrete / Block.
Suitable BOSCH
Angle Grinders MAKITA
Milwaukee
DEWALT
Metabo
FLEX
L21-8 180, L21-6 230, L24-6 230, L26-6 230
GWS24-180 / H / J / JH / LV, GWS24-230 / H / J / JH / LV
GWS20-180 / H / J / JH, GWS20-230 / H / J / JH, GWS22-180 / H / J / JH / LV, GWS22-230 / H / J / JH / LV,
GA7020 / 7040 / 7050 / 7060 / 9020 / 9030 / 9040 series.
AG22-180, AG22-230, AG22-230E
DWE490 / 492 / 492S / 493 / 494, D28413 / 28490 / 28492 / 28498 / DWE4559 / DWE4579 / DWE4599
(W / WE) 22-180MVT, (W / WE / WEA / WEPB / WEPBA) 24-180MVT, W26-180MVT, (W / WE) 22-230MVT,
(W / WE / WEP / WEA / WEPB / WEPBA) 24-230MVT, (W / WE / WEA / WEPBA) 26-230MVT
NKC-180 Dust Extractor
INSTRUCTION MANUAL
・DO NOT use the HURRICANE ALPHA with non-approved angle grinders. Please check against list below.
・HURRICANE ALPHA is only for grinding concrete and block. DO NOT use for grinding steel or other materials.
・HURRICANE ALPHA must be used with a vacuum designed and approved for concrete dust.
・HURRICANE ALPHA is only for use with Diamond Grinding Cup. DO NOT use with abrasive grinding wheels.
・Always check the HURRICANE ALPHA for damage, cracks, or deformation before use.
・DO NOT use the HRRICANE ALPHA if it is cracked, damaged or bent as this could lead to injury.
・Be sure to wear protective goggles, dust mask, protective gloves and foot wear, earplugs and other protective equipment when working.
・Keep the HURRICANE ALPHA away from gasoline, solvents, and paraffin.
・Ensure the work piece is securely clamped before working.
[a] Main Body / [b] Metabo Ring / [c] Adaptor / [d] Centering Holder / [e] Flange Bolt / [f] Base Flange
[g] Spacer T3.4 / [h] Spacer T6.0 / [ i ] Spacer T7.5 / [k] Spacer T9.4 / [m] Spacer T10.6
[n] Bolt (L60) / [o] Bolt (L45) / [p] Hex Wrench / [q] Hose Connector
Metabo / Dewalt DWE4579 type
1. [Metabo / Dewalt DWE4579 type]
Remove the Lever unit and O-ring
(WX22-230 and W24-230 only) , then
set [b] Mount Ring on the Gear Case.
(Fig.2)
2. Set [c] Adaptor around the Gear
Case with the Hooks securely stored
into the groove at Gear Case.
(Fig.3)