National Instruments NI PXI-1006 User manual

PXI™and National Instruments™ are trademarks of National Instruments Corporation.
323091A-01 ©Copyright 2001 National Instruments Corp. All rights reserved. April 2001
INSTALLATION GUIDE
PXI -1006 RACK MOUNT
To mount the PXI-1006 in an instrument rack, follow the steps below.
Figure 1. PXI-1006 in Rack Mount Configuration
1. Remove the rubber feet and bottom feet (as required) from the
PXI-1006 chassis.
2. Install the mounting brackets onto each side of the chassis using the
M4 x 8 flathead screws supplied. Note that you can recess the chassis
in the cabinet rack at 1 in. increments up to 3 in. (For reverse mounting,
install the brackets using the holes at the back of the chassis.)
3. Install the chassis in the instrument rack using four screws (not
supplied).
1 Mounting Bracket
2 M4 x 8 Flathead Screw (Qty. 8)
3 Rubber Feet
4 Bottom Feet
5 Holes for Reverse Mounting
™
1
2
4
3
5
1
4