1.Input Jack
Connects the guitar to the amplifier.
2.Gain Control
This controls the level of gain on the
normal.
3-5.Bass, Middle & Treble
Experimenting with these three wide
ranging interactive bands of
equalisation will give you a clearer
understanding of the versatile
Nativo tones available from
this channel.
6.Boost Select
Clean to boost chanel selector swich.
Thisfunction is also footswitchable.
Set the switch to the in position for
the footswitch to function.LED`s
indicate which mode has been
selected.
BOOST CHANNEL
7.Gain Control
Control for the gain level of the boost
channel.This takes sound from bluesy
distortion on lower settings to all out
metalon maximum.
8.Volume Control
Controls the volume level of the
boost channel.
9-11.Bass & Treble
Interactive EQ controls covering the
lower thounh to the upper frequencies
and offering accurate sound tailoring.
10.Contour Control
Mid-band contour shift, wide voicing
sweep for maximun tonal versatility
on overdrive selections. When used
in conjuction wih the EQ, this control
is highly effective.
12.Reverb
Controls the level of the reverb effect
on both channels.
LED’s indicate which mode has been
selected.
13.Footswich Jack
For the connection of a two way
footswich for reverb and channel
selection.
14.Pre Amp Out
Direct output from the pre-amp. This
gives a signal suitable for driving an
external power amp or the input of
an effects processor.
15.Power Amp In
Input directly into the power Amp. This
allows the use of an external pre-amp,
or acts (in conjunction with pre-amp out)
as the return input from an external
effects processor.
90 Watt COMBO
NORMAL CHANNEL
BOOST
SELECT
FOOT
SWITCH
PRE AMP
OUT
Guitar Tube SimulatorGuitar Tube Simulator
TREBLE
GAIN VOLUME
NORMAL CHANNEL
BASS CONTOUR
BOOST CHANNEL
10
BASS MIDDLE
10
0
TREBLE
10
0
ON
10
010
010
010
010
010
0
REVERB
ON
INPUT
POWER
AMP IN
0
10
0
GAIN POWER
I
1 2 3 4 5 6 7 8 9 10 131211 14 15
Rear Panel Features
1.External Speaker
If using an external speaker in
conjunction with the internal speaker, the
external speaker should be rated at 8 ohms.
2.Out Line
The Line Out can be used for connection
to recording equipment for direct recording
or for connection to a P.A. System.
3
GTS 90GTS 90
Nativo GTS 90 :Nativo GTS 90 :
