NE kids X080 User manual

STUDENT LOFT BED
Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Item No. X080
1. Follow the information on the warnings appearing on the upper bunk end structure and on the
carton. Do not remove warning label from bed.
2. Always use the recommended size mattress or mattress support, or both, to help prevent
entrapment or falls.
3. Surface of mattress must be at least 5 inches (127 mm) below the upper edge of guardrails.
4. Do not allow children under 6 years of age to use the upper bunk.
5. Prohibit more than one person on the upper bunk.
6. Periodically, check and ensure that the guardrail, stairs, and other components are in their proper
position, free from damage, and that all connectors are tight.
7. Do not allow horseplay on or under the bed and prohibit jumping on the bed.
8. Always use the stairs for entering and leaving the upper bunk.
9. Do not use substitute parts. Contact the manufacturer or dealer for replacement parts.
10. Use of a nightlight may provide added safety precaution for a child using the upper bunk.
11. Always use guardrails on both long sides of the upper bunk. If bunk bed will be placed next to the
wall, the guardrail that runs the full length of the bed should be placed against the wall to prevent
entrapment between the bed and wall.
12. The use of water or sleep otation mattresses is prohibited.
13. Keeptheseinstructionsforfuturereference.
!
!STRANGULATIONHAZARD
Never attach or hang items to any part of the bunk bed that are not designed for use with the bed;
including, but not limited to, hooks, belts and jump ropes
SIZEOFMATTRESSANDFOUNDATION
Use only mattress, foundation and deck combined which is 74-75 inches long and 37 ½-38 ½ inches wide
on upper bunk. Ensure thickness of mattress and foundation combined does not exceed 8 inches and the
mattress is at least 5 inches below upper edge of guardrails.
SAFETYWARNINGS
SAFETYFIRST!
All of NE kid’s Bunkbeds were
designed and manufactured with
yourchild’ssafetyasourtop
priority.
Their unparalleled strength is a
bi-product of the safety design.
Our bunks meet all compliance
with ASTM F 1427-07 “Standard
Consumer Safety Specication
for Bunk Beds” and Code of
Federal Regulations (CFR) 1213
“Safety Standards for Entrapment
Hazards in Bunk Beds” and
(CFR) 1513 “Requirements for
Bunk Beds”.
Safety is a cooperative effort
between us as the manufacturer,
and you as a guardian. Please
readandconsiderthe
warningslistedonthispage
when choosing a mattress and
discussing rules of use with your
child.
REPLACEMENTPARTS
Replacement parts, including
additional guardrails, may be
obtained from any of NE kids’
dealers.
Page 1 of 17

Page 2 of 17
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Enclosedpleasendsimplestep-by-step
instructionstohelpyouquicklyassemble
yourproduct. Before you begin we recommend
that you follow the steps below:
Please read the instructions thoroughly
Identify all parts and hardware
Gather the tool(s) necessary
2 adults required for assembly
Toprotectyourparts during assembly please
place them on a soft surface.To clean surface use
only water on a damp cloth. Do not use window
cleaners or cleaning abrasives as it will scratch
the surface and could damage the protective
coating.
CUSTOMERSUPPORT
If you are missing parts or need assistance with
your product, please contact the retailer from
whom you purchased the product. When you
call or email, please include the Product’s Item
Number and PO Number which is located on
the Production Tracking Sticker. This sticker can
be found on the bottom, inside or back of your
product.
1.
2.
3.
4.
INTRODUCTION
STUDENT LOFT BED
Item No. X080
Assembly Instructions
Fully Assembled
Student Loft

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 3 of 17
J
10mm Wood Dowels
X4
Allen Wrench
X1
K
L
PARTS LIST
H
30mm Screws
X26
1
2
3
4
7
8
9 10
5
6
C
60mm Bolts
X16
F
Barrel Nuts
X24
D
40mm Bolts
X23
25mm Bolts
X2
T-Nuts
X2
Ladder Hooks
X2
A100mm Bolts
X8
B
G
8mm Wood Dowels
X12
E
45mm Screws
X4
I
20mm Screws
X12
11
Top
Bottom
Left & Right Desk Hutch Side Panels
X1ea.
Desk Hutch
Top Panel
X1
Desk Cabinet
X1
Bookcase
Top Panel
X1
Bookcase
Side Panel
X1
Bookcase
Drawer Chest
X1
Bookcase
Shelves
X2
Desk Top
X1
Desk Hutch Back Supports
X1(of each type)

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 4 of 17
PARTS LIST (CONTINUED)
Ladder
X1
Rear Guard Rail
X1
Front Guard Rail
X1
15 16 17
Head/Footboards
X2
12
Set of Slats
X1
14
Rails
X2
13
Other Tools Required
(Not Included)
• Phillips Screwdriver
• Flathead Screwdriver

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 5 of 17
For left-hand Desk/Ladder
follow directions as indicated.
For right-hand Desk/Ladder
follow directions as indicated but
please note inset drawings.
NOTE: Before beginning assembly, decide exactly where the bed is to be placed
and on which ends you would like the the Desk/Ladder and Bookcase. Both the
Bookcase and Desk can be placed at either end and reversed. See below.
!

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 6 of 17
STEP 1STEP 2
Remove drawers from chest. Assemble Drawer Chest, Shelves
and Bookcase Side Panel
X2
X2
X2
X2
B
B
B
B
B
B
B
B
E
E
E
E
1
1
2
3
3

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 7 of 17
STEP 3STEP 4
Withtwoadults, lift the Bookcase into desired position
then replace the Drawers.
Attach Head/Footboard to Bookcase Top Panel then attach Top Panel to Bookcase.
Left-hand Bookcase
(Right-hand Desk/Ladder)
C
C
C
C
C
C
C
C
4
4
12
12

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 8 of 17
STEP 5
Loosely afx Desk Top to Right Desk Hutch Side Panel (do not completely tighten
bolts). Remove drawers from Desk Cabinet, then attach Right Desk Hutch Side
Panel to Desk Cabinet.
X2
X2
C
C
For outside-facing Desk assembly,
please continue with
Step 6 on Page 9.
For inside-facing Desk assembly,
please skip to
Step 6A on Page 11.
NOTE: Before continuing assembly, decide whether
you would like the Desk to be outside-facing or
inside-facing and follow instructions below. For use
of the Lower Bed with the Student Loft, Desk must be
outside-facing.
!
10
5
5
F
F
B
B
E
E
10
8

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 9 of 17
STEP 6
Fit Desk Hutch Back Supports, Desk Top, and
Left Desk Hutch Side Panel together using wood
dowels(12).
Steps 6-8: Outside-facing Desk assembly
STEP 7
Secure Desk Hutch Side Panels and
Back Supports as shown and tighten
any bolts that were left loose.
FRONT VIEW
REAR VIEW
J
J
B
B
B
B
B
B
B
F
F
F
F
F
F
F
F
F
F
E
E
E
E
E
E
E
K
K
D
7
8
9
6
10
5

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 10 of 17
Attach Desk Hutch Top Panel.
STEP 8
Skip to Step 9 on Page 12
C
C
C
C
D
D
D
11

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 11 of 17
Fit Desk Hutch Back Supports, Desk Top, and
Left Desk Hutch Side Panel together using wood
dowels(12).
Secure Desk Hutch Side Panels and Back
Supports as shown and tighten any bolts that
were left loose.
REAR VIEW
J
J
B
B
B
B
B
B
F
F
F
F
F
F
F
F
F
F
E
E
E
E
E
E
E
K
K
D
STEP 8ASTEP 6A STEP 7A
Attach Desk Hutch Top Panel.
C
C
C
C
D
D
D
Steps 6A-8A: Inside-facing Desk assembly
7
8
9
6
10
5
11

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 12 of 17
STEP 10
Attach Headboard to the top of the Desk Hutch.
Steps 10-14: Upper Bed assembly
STEP 9
Withtwoadults, move the Desk Hutch into position
then replace the drawers.
For inside-facing
Desk assembly
For outside-facing
Desk assembly
CC
CC
CC
CC
12 12

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 13 of 17
STEP 11
Loosely attach Desk Hutch,
Bed Side Rails and Bookcase
(do not completely tighten
bolts until Step 13).
Detail for all four corners
I
I
I
I
A
A
A
A
E
E
E
E13
13

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 14 of 17
STEP 12
Lay slat roll between side rails and screw in slats to slat support as
indicated. Make sure rails are pulled into slats prior to screwing in place.
To help prevent serious or fatal injuries SCREWBOTHSIDES
OFEACHSLATTOTHESLATSUPPORT. Failure to do so
could result in the collapse of the entire slat roll, and will void
your warranty.
WARNING
!
Attach Slats.
G
G
G
14
14

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 15 of 17
Position Guard Rails in place, tighten all Bed Side Rail bolts completely, then attach
Guard Rails as shown. Note: Ladder opening must be on the Desk end of the bed.
Inside detail
Detail for 3 corners
STEP 13
Right-hand Desk/Ladder
H
H
H
C
15
15
16
16

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 16 of 17
Attach Ladder Hooks to Ladder, then attach Ladder to Upper Bed.
Inside detail
STEP 14
L
L
17
H
H
H
H
Note: Please ensure that
the bolts for Ladder rungs
are tight before using.

STUDENT LOFT BED - Assembly Instructions
NE kids · 2300 Prospect Dr. Christiansburg, VA 24073 · www.ne-kids.com
NE
k i d s
Page 17 of 17
CARE INSTRUCTIONS
• A lacquer nish is used on this furniture to protect the wood. It is not waterproof, clean
spills immediately. Dust using a slightly damp cloth, making sure no standing water is
left on the furniture. DO NOT use any household cleaners, citrus-based polishes, wood
soaps, or oils; they can break down the natural lacquer nish.
• Do not place furniture in direct sunlight. Natural solid wood furniture will naturally
color as it ages, however, direct sunlight dramatically speeds up the process.
• In natural wood furniture, the variations in texture and grain will affect the nish,
making it impossible to guarantee an exact match between two pieces of wood even
though identical nishing processes are used. These differences in character are not
defects, but variations that make each piece of furniture unique and beautiful.
• Solid wood naturally expands and contracts. In high humidity you may nd that
drawers can stick slightly. This will correct itself, and is not reason for concern.
• Do not place furniture over heating or cooling vents. Dramatic changes in
temperature can cause the wood to split.
• If you place objects such as lamps or plants on your case pieces make sure to move
them from time to time. There may be a slight discoloration where the object was.
However, by exposing it to light the color will catch up to the rest of the case.
• Plastic or foam footed items such as phones or clocks can damage this nish, use
trivets under such items.