Neic HMGT1000C User manual

GPS/GLONASS Trip
Meter
HMGT1000C
1
Copyright © 2014 Hummingbird Electronics Pty Limited
Introduction ............................................................................................................................................................................... 2
Features.......................................................................................................................................................................................... 2
Optional Accessories ...................................................................................................................................................................... 3
Package Contents ....................................................................................................................................................................... 4
Installation ................................................................................................................................................................................. 5
Navigating the Menu .................................................................................................................................................................. 5
Main Display ............................................................................................................................................................................. 6
Main Menu................................................................................................................................................................................. 6
Preload Trips................................................................................................................................................................................... 7
Setup Menu .................................................................................................................................................................................... 8
Freeze Setup Menu.................................................................................................................................................................... 9
Contrast Setup Menu .............................................................................................................................................................. 10
Speed Limit Setup Menu ........................................................................................................................................................... 9
Backlight Setup Menu ............................................................................................................................................................. 10
Calibrate Tripmeter.................................................................................................................................................................. 10
Technical Specifications ............................................................................................................................................................ 11
Table Of Contents

GPS/GLONASS Trip
Meter
HMGT1000C
2
Copyright © 2014 Hummingbird Electronics Pty Limited
Congratulations on your purchase of a Hummingbird Electronics HMGT1000C GPS/GLONASS Trip
Meter. All Hummingbird Electronics products are manufactured to the highest standards of
quality and will provide many years of reliable service.
Introduction
Features
Utility
•2 trip counters.
•Individual count up/down, freeze, reset.
•External reset switch.
•No connection to vehicle required.
Functionality
•Statistics display.
•Current position.
•Preloadable trips.

GPS/GLONASS Trip
Meter
HMGT1000C
3
Copyright © 2014 Hummingbird Electronics Pty Limited
`
Optional Accessories
GPS/GLONASS Antenna - Bulkhead Mount
GPS Antenna - Stubby
Ram Mount, Various

GPS/GLONASS Trip
Meter
HMGT1000C
4
Copyright © 2014 Hummingbird Electronics Pty Limited
Package Contents
1 x HMGT1000C GPS/GLONASS Trip
Meter
1 x GPS/GLONASS Antenna -
Magnetic/SMA
1 x wiring loom –handheld reset switch,
car power adapter, integrated fuse
1 x RAM 1“ diameter ball mount
1 x RAM suction cup base

GPS/GLONASS Trip
Meter
HMGT1000C
5
Copyright © 2014 Hummingbird Electronics Pty Limited
1) Ensure that power to the vehicle is isolated.
2) Mount the HMGT1000C Trip Meter on your preferred surface (e.g. dashboard) using the
supplied ball or suction mount.
3) Insert the power connector into the vehicle’s accessory power socket (12V DC or 24V DC).
4) Plug the 6-way connector on the wiring loom into the Trip Meter.
5) Screw the GPS/GLONASS antenna connector onto the female connector located on the
back panel of the Trip Meter. Do not close the antenna cable in the door of the vehicle;
in most applications, leaving the antenna on the dashboard of the car will surfice.
6) Restore power to the vehicle and apply power to the Trip Meter
The Trip Meter should, under normal circumstances, operate with at least 7
satellites. Should performance degrade inspect the GPS/GLONASS antenna for
wear or damage. The antenna may require replacement after several years
depending upon vehicular and environmental conditions.
Installation
Navigating the Menu
From the Main Display, the Menu key will enter the main menu;
from the main menu, Menu is used to step back one level, the
arrow keys navigate through a menu and to select the
highlighted item.

GPS/GLONASS Trip
Meter
HMGT1000C
6
Copyright © 2014 Hummingbird Electronics Pty Limited
The odometric functions of the Trip Meter utilise GPS and GLONASS technology
and, given good satellite coverage, achieve greater than 99% accuracy. The
number of satellites currently tracked by the device is shown in the lower-right
corner of the display; while four is the minimum number required to obtain
speed readings, seven to ten is typical.
Reset Trip B
Resets trip B to zero.
Current Position
Displays the vehicle’s current latitude
and longitude. Press Menu to return to
the menu. Change the displayed units
using the Setup Menu.
Trip A Dir
Sets the direction of trip A. Press
Enter to cycle between Up, Down or
Select. Select enables the use of the
arrow keys to change direction
from the main display.
Trip B Dir
As above, but for trip B.
Average Based On:
Set the trip on which to base average
speed. Press Enter to toggle between
trip A and trip B.
Show Statistics
Display detailed trip information. Press
Menu to return to the menu.
Preload Trips
Allows the user to preload either trip A
or trip B.
Main Display
The main display shows the two trip counters, satellite count, current
and average speed. The arrow keys select the direction of trip A or B if
set to do so in the configuration menu (see below).
Main Menu

GPS/GLONASS Trip
Meter
HMGT1000C
7
Copyright © 2014 Hummingbird Electronics Pty Limited
Setup
Displays the general setup menu where
the user can change units, switch
function etc.
Preload Trip A
Preload Trip A. Use the arrow keys to choose
a number and the enter key to advance to
the next digit.
Preload Trip B
Preload Trip B. Press the arrow keys to
choose a number and the enter key to
advance to the next digit. Press enter to exit
and save.
Reset A…
Sets the action to take on trip B when Trip A is
reset. In “preload” mode, trip B will be
preloaded with the value set using the Preload
Trip B function above. In “leave” mode, Trip B
will remain at its current value. Press Enter
to toggle between modes.
Preload Trips

GPS/GLONASS Trip
Meter
HMGT1000C
8
Copyright © 2014 Hummingbird Electronics Pty Limited
Unit
Set the display units to kilometres,
miles, nautical miles or metres per
minute. Press Enter to cycle.
Ext Switch
Press Enter to toggle between
enabling and disabling the external
reset switch.
Freeze Options Menu
Displays the Freeze Setup Menu
which allows the user to
optionally pause trips when the
reset button is pressed.
Set Speed Warning
Displays the Speed Warning
Setup Menu which allows the
user to set a maximum speed
above which the buzzer will
sound.
Set Display Contrast
Displays the Contrast Setup Menu.
Set Display Brightness
Displays the Backlight Setup Menu.
Calibrate Tripmeter
Displays the Calibration Menu
which allows the user to scale
distance to match it to another
instrument if required.
Decimal Places-A
Press Enter to cycle from 0 to 3
decimal places shown.
Decimal Places-B
Press Enter to cycle from 0 to 3
decimal places shown.
LAT/LON in…
Press Enter to toggle between DEG
(degrees) and DMS (degrees, minutes,
seconds).
Up/Down:…
Selects the function of the arrow
keys on the main display. Press
Enter to toggle between Direction
and Distance.
TripB: Small/Enlarged
Press Enter to toggle between a
small or enlarged trip B.
Setup Menu

GPS/GLONASS Trip
Meter
HMGT1000C
9
Copyright © 2014 Hummingbird Electronics Pty Limited
Set to Defaults
Restore all settings to defaults.
Factory Config
For administrative use only.
Rev
Displays the software revision number.
Freeze…
The freeze function allows one to freeze the
current trip value on the screen when the reset
button is pressed. Press Enter to cycle between:
Disabled –no freeze function
A Enabled –freeze enabled on trip A only
B Enabled –freeze enabled on trip A only
AB Enabled –freeze enabled on trip A and trip B
Count/Halt During Freeze
Press Enter to toggle between
continued counting during freeze
and stopping the count during
freeze. If counting is stopped during
freeze, any distance travelled
between enabling and disabling
freeze will not be measured.
Auto Unfreeze
Press Enter to enable or disable
automatic un-freezing after 3
seconds.
Limit
Use the arrow keys to set.
Press Enter To Save
The setting will be retained when
the unit is powered off.
Press Menu To Exit
The previous setting is retained.
Freeze Setup Menu
Speed Limit Setup
Menu

GPS/GLONASS Trip
Meter
HMGT1000C
10
Copyright © 2014 Hummingbird Electronics Pty Limited
Contrast
Use the arrow keys to set the
display contrast.
Press Enter To Save
The setting will be retained when
the unit is powered off.
Press Menu To Exit
The previous setting is retained.
Brightness
Use the arrow keys to set display
brightness
Press Enter To Save
The setting will be retained when
the unit is powered off.
Press Menu To Exit
The previous setting is retained.
Adjust Tripmeter by:
Use the arrow keys to set the
percentage by which the displayed
trip will be adjusted. The unit does
not require calibration to measure
and display distance accurately. This
function can however be used to
adjust the display to another
instrument.
Press Enter To Save
The setting will be retained when
the unit is powered off.
Press Menu To Exit
The previous setting is retained.
Contrast Setup Menu
Backlight Setup Menu
Calibrate Tripmeter