NeoGuard MotionPet User manual

NEOGUARD MOTIONPET
PET IMMUNE MOTION SENSOR
USER’S MANUAL
The NeoGuard MotionPet works
only in combination with the
NeoGuard One Starter Set

NEOGUARD MOTIONPET
PACKAGE CONTENTS
With the NeoGuard MotionPet the NeoGuard Smart Home System can register movements
within the sensor’s detection range and send signals to the Main Panel which will then
trigger an alarm. There are multiple settings, under which circumstances an alarm should be
triggered. The motion sensor doesn’t register moving objects under 12kg and doesn’t trigger
an alarm, which makes it a perfect motion detector for pet owners.
1 x NeoGuard MotionPet
1 x Mounting Bracket (2-parts)
2 x Fixing Screws
1 x Protection Screw
1 x 6F22 9V Battery
LED Indicator
LED red: Motion Detection
LED yellow: Low Battery
Detection Range
Latching Mechanism
with Protection Screw
Mounting Bracket

GETTING STARTED
Launch the NeoGuard app
and go to “Settings” (swipe
left once)
Press the “+” icon in the
top right corner
Scan the QR code, it can be
found on the rear side of the
moton sensor
Name the device > Choose a
Trigger Mode >
“Save” > “Yes”
iOS: Send
Open the MotionPet
Attach the mounting bracket to
a wall using the two provided
screws
Connect the two parts of the
bracket (insert the ball into the
opening) and x the motion
sensor on the bracket
Unwrap the battery and
insert it properly. Close the
MotionPet and tighten the
protection screw

Disable:
The alarm won’t be triggered upon detecting a motion
Instant: Activated when ARM/HOME ARM
When the NeoGuard Smart Home System is armed or in
Home Arm mode an alarm will be triggered as soon as a
motion has been detected
24 Hours: Activated even when DISARMED
An alarm will be triggered even if the system is disarmed
Home: Deactivated when DISARM/HOME ARM
An alarm will only be triggered if the system is armed; no
alarm will be triggered if the system is in Home Arm mode
Door Chime: No alarm but clanking
The sound of a doorbell will ring upon detecting a motion
Entry Delay: Wait few seconds before alarm
The alarm will be triggered only after a few seconds
upon detecting a motion
“Accessories Management” >
“Security Accessories” >
e.g. “MotionSensor2“
Remind: Trigger Beep On/Off: If you activate the Remind feature a short beep will sound every
time the NeoGuard MotionPet detects a motion
TRIGGER MODES
NeoGuard MotionPet
Operating Voltage DC 9V
Battery 1 x 6F22 9V battery
Operating Current ≤15mA
Power Consumption (Standby) 25μA
Detection Angle 110°
Detection Distance 9-12m
Pet Immunity ≤12kg
Transmission Distance 100m (without obstacles)
Transmission Frequency 433.29MHz
Working Temperature -10˚C~50˚C
Relative Humidity ≤95%rh (non-condensing)
Weight 65.7g (without battery)
100.3g (with battery)
Dimensions (HxWxL) 106 x 62 x 46 mm
TECHNICAL SPECIFICATIONS
Balter Security GmbH
Elisabeth-Selbert-Str. 19
40764 Langenfeld
Germany
www.neoguard.biz
E-Mail: [email protected]