Ness 101-043 User manual

101-043
Quick Guide
101-043
STAND-ALONE SINGLE DOOR SYSTEM

Enter Program mode
Note:
You need to be in
Normal mode first
Mode LED should
be green
Factory Default:
1234
Press # for 2 seconds
Enter your 4-digit installer code (Default: 1234)
Exit Program mode
Press # for 2 seconds
Enter / Exit Secure mode
Factory Default:
3838
Enter your Secure code
Press #
Mode LED:
Green = Not in secure mode
Red = In Secure Mode
Set a new open code
Factory Default:
2580
Enter Program Mode
Press 1
Enter your new 4-Digit open code
Set a new Aux code
Factory Default:
0852
Enter Program Mode
Press 2
Enter your new 4-Digit Aux code

Set a new Program code
Enter Program Mode
Press 3
Enter your new 4-Digit Installer code
Set a new unlock time
Factory Default:
0005 Seconds
Enter Program Mode
Press 6
Enter your new 4-Digit number
First Digit –(fail safe or fail secure lock)
0 = fail safe lock
1 = fail secure locks
Second Digit –(Tamper siren time)
Tamper siren time (1-9 mins)
Third and forth digit –(lock activation time)
01 = 1 second
99 = 99 seconds
Example:
If we want to set the lock activation time for 12 seconds and work with fail secure
lock and with 5 seconds tamper siren time then we would set the 4 digits number
to 1512.

Add a new code
Factory Default:
none
Enter Program Mode
Press 7
Enter user number ( 001 –500 )
Present Card or Enter 4-digits
Delete a code
Factory Default:
none
Enter Program Mode
Press 8
Enter user number ( 001 –500 )
Enter Installer code to confirm (default: 1234)
Factory Default Settings
Factory Default:
none
Warning: This will erase the entire memory and settings including user codes.
Enter Program Mode
Press 0
Enter Program code to confirm (default: 1234)
Replace a lost installer code
Factory Default:
none
Remove power from the unit
Press the REX button (or short out REX/BL and GND)
Power the unit up
Release the REX button
You have 15 seconds to program a new installer code into the unit