NetModule NB1601-R User manual

www.netmodule.com 03.09.2019 © NetModule AG | Errors reserved
Quick Start Guide Enclosure
NB1601
2
1
3
4
1 Status LED Status indicator.
—Blinking: Device busy; device is in startup, software- or
conguration update.
—On: The device is ready
2 Reset Press at least 3 seconds for reboot and at least 10 second
for a factory reset. The start of the factory reset is conr-
med by all LEDs lighting up for a second. The button must
be released immediately afterwards.
3 USB USB 2.0 host port
4 Ethernet Connect your router by using the ETH 1 port with your
computer to start the conguration. Your router is
congured as a DHCP server by default and has the IP
address 192.168.1.1. Open this IP in your browser to reach
the WEB-GUI.
5LTE SMA female connectors for LTE antennas. For MOB 1, A1 is
the main, A2 the auxiliary port.
6 Bluetooth LE SMA female connector (A3) for Bluetooth.
6
5
8
7
9
11
10

www.netmodule.com 03.09.2019 © NetModule AG | Errors reserved
Quick Start Guide Enclosure
NB1601
7 WLAN SMA female connectors for MIMO WLAN antenna. A3 is
the main port, A4 is the auxiliary port. If only one WLAN
antenna is used, it must be attached to port A3.
8 GNSS SMA female connector for GNSS antenna.
9 Power The router can be powered with an external source with
the nominal input voltages 12VDC and 24VDC.
10 SIM cover Removing the SIM cover: Loosen the screw, remove it and
then remove the cover.
Please close the cover again after inserting the SIM cards.
11 SIM holder Slots for 2 Micro SIM (3FF).
The card holders can be opened by sliding them carefully
in the direction indicated by the arrow in the drawing
below and lift it up.
Then insert the SIM cards with the chip facing to the back.
Close the holder again and shift it back until it’s locked.
Please close the SIM cover after inserting the SIM card
and tighten the screw again.
SIM 2
SIM 1