NetModule NB3701 User manual

www.netmodule.com 30.12.2019 © NetModule AG | Errors reserved
Quick Start Guide Enclosure
NB3701
1
7
2 4 43 5
6
9
8
1 Status LED Status indicator.
— Status blinking: The device is busy due to startup, soft-
ware or conguration update.
— Status on: The device is ready.
2 Reset button Press at least 3 seconds for reboot and at least 10 seconds
for a factory reset. The start of the factory reset is conr-
med by all LEDs lighting up for a second. The button must
be released then again.
3 SIM cover Removing the SIM cover: Loosen both screws, then remo-
ve the screw in the bottom left corner and flip over the SIM
cover until the SIM card holder is completely free.
Please close the cover after
inserting a SIM card and
tighten the screws again.

www.netmodule.com 30.12.2019 © NetModule AG | Errors reserved
Quick Start Guide Enclosure
NB3701
4 SIM slots Slots for 2 Mini SIM (2FF) cards. The SIM cards can be
inserted by sliding it into one of the designated slots on the
front panel.
Push the SIM cards with the chip facing down using a small
paper clip (or similar) until they snap into place.
To remove the SIM cards, you will need to push them again
in the same manner. The SIM cards will then pop out and
can be pulled out.
5 USB USB 2.0 host port.
6 Ethernet Connect your router by using the Ethernet 1 port with
your computer to start the conguration. Your router is
congured as a DHCP server by default and has the IP
address 192.168.1.1. Open this IP in your browser to reach
the WEB-GUI.
7 Power The router can be powered with an external source with
the nominal input voltages 24VDC, 36VDC and 48VDC
or, if the router is equipped with power supply type Pb,
72VDC, 96VDC and 110VDC.
8 LTE or WLAN TNC female connectors for LTE/UMTS or WLAN anten-
nas.
— LTE 1: A1 main, A4 auxiliary
— LTE 2: A2 main, A5 auxiliary
— WLAN 1: A2 main, A5 auxiliary
— WLAN 2: A1 main, A4 auxiliary
9 GNSS TNC female connector for GNSS antenna.
SIM 1
SIM 2