NetModule NB2800 User manual

www.netmodule.com 31.12.2019 © NetModule AG | Errors reserved
Quick Start Guide Enclosure
NB2800
12 43 5
1 LED Status indicator.
—STAT blinking: The device is busy due to startup, soft-
ware or conguration update.
—STAT on: The device is ready.
2 USB USB 3.0 host port
3 SIM slots Slots for 4 Micro SIM cards (3FF). SIM cards can be
inserted by sliding it into one of the designated slots on
the front panel. Push the SIM cards with the chip facing
down using a small paper clip (or similar) until they snap
into place:
To remove the SIM cards, you will need
to push them again in the same manner.
The SIM cards will then pop out and can
be pulled out.
6 7 97
8 78 7 10

www.netmodule.com 31.12.2019 © NetModule AG | Errors reserved
Quick Start Guide Enclosure
NB2800
4 SIM cover Removing the SIM cover: Loosen both screws and flip over
the SIM cover until the SIM card holder is completely free.
Please close the cover after inserting a SIM card and
tighten the screws again.
5 Reset button The reset button is accessible through a small hole in the
right of the SIM card slots. Press at least 3 seconds for re-
boot and at least 10 second for a factory reset. The start of
the factory reset is conrmed by all LEDs lighting up for a
second. The button must be released then again.
6 Ethernet Connect your router by using the ETH 1 with your compu-
ter to start the conguration. Your router is congured as a
DHCP server by default and has the IP address 192.168.1.1.
Open this IP in your browser to reach the WEB-GUI.
7LTE FAKRA connectors for MIMO LTE antennas. The left port
is always the main port.
8 WLAN FAKRA connectors for MIMO WLAN antennas. The left
port is always the main port.
9 Power and
Ignition Sense
The router can be powered with an external source with
the nominal input voltages 12VDC, 24VDC, 36VDC and
48VDC.
For power, use the pins 1 (VGND) and 2 (V+). For ignition
sense, use pin 3 (IGN).
10 Extension
port cover
Connector for extensions. Please nd detailed information
in the router manual.