NetModule NB2800 User manual

www.netmodule.com 8/7/2017 © NetModule AG | Errors reserved
NB2800 Overview
1
LED
Status indicator.
- STAT blinking: The device is busy due to startup,
software or configuration update.
- STAT on: The device is ready.
2
USB
USB 3.0 host port
3
SIM slots
Slots for 4 Micro SIM cards (3FF). SIM cards can be
inserted by sliding it into one of the designated slots on
the front panel. Push the SIM cards with the chip facing
down using a small paper clip (or similar) until they snap
into place:

www.netmodule.com 8/7/2017 © NetModule AG | Errors reserved
To remove the SIM cards, you will need to push them
again in the same manner. The SIM cards will then pop
out and can be pulled out.
4
SIM cover
Removing the SIM cover: Loosen both screws and flip
over the SIM cover until the SIM card holder is
completely free.
Please close the cover after inserting a SIM card and
tighten the screws again.
5
Reset button
The reset button is accessible through a small hole in the
right of the SIM card slots. Press at least 3 seconds for
reboot and at least 10 second for a factory reset. The
start of the factory reset is confirmed by all LEDs lighting
up for a second. The button must be released then
again.
6
Ethernet
Connect your router by using the ETH 1 with your
computer to start the configuration. Your router is
configured as a DHCP server by default and has the IP
address 192.168.1.1. Open this IP in your browser to
reach the WEB-GUI.
7
LTE
FAKRA connectors for MIMO LTE antennas. The left port
is always the main port.
8
WLAN
FAKRA connectors for MIMO WLAN antennas. The left
port is always the main port.
9
Power and
Ignition
Sense
The router can be powered with an external source with
the nominal input voltages 12VDC, 24VDC, 36VDC and 48VDC.
For power, use the pins 1 (VGND) and 2 (V+). For ignition
sense, use pin 3 (IGN).
10
Extension
port cover
Connector for extensions. Please find detailed
information in the router manual.