NetModule NB1601 Installation guide

www.netmodule.com 9/11/2018 © NetModule AG | Errors reserved
NB1601 Overview
1
Status LED
Status indicator.
- Blinking: Device busy; device is in startup,
software- or configuration update.
- On: The device is ready
2
Reset
Press at least 3 seconds for reboot and at least 10
second for a factory reset. The start of the factory
reset is confirmed by all LEDs lighting up for a
second. The button must be released immediately
afterwards.
3
USB
USB 2.0 host port
4
Ethernet
Connect your router by using the ETH 1 port with
your computer to start the configuration. Your
router is configured as a DHCP server by default
and has the IP address 192.168.1.1. Open this IP in
your browser to reach the WEB-GUI.
5
LTE
SMA female connectors for LTE antennas. For MOB
1, A1 is the main, A2 the auxiliary port.
6
Bluetooth LE
SMA female connector (A3) for Bluetooth.

www.netmodule.com 9/11/2018 © NetModule AG | Errors reserved
7
WLAN
SMA female connectors for MIMO WLAN antenna.
A3 is the main port, A4 is the auxiliary port. If only
one WLAN antenna is used, it must be attached to
port A3.
8
GNSS
SMA female connector for GNSS antenna.
9
Power
The router can be powered with an external source
with the nominal input voltages 12VDC and 24VDC.
10
SIM cover
Removing the SIM cover: Loosen the screw, remove
it and then remove the cover.
Please close the cover again after inserting the SIM
cards.
11
SIM holder
Slots for 2 Micro SIM (3FF).
The card holders can be opened by sliding them
carefully in the direction indicated by the arrow in
the drawing below and lift it up.
Then insert the SIM cards with the chip facing to the
back.
Close the holder again and shift it back until it’s
locked. Please close the SIM cover after inserting
the SIM card and tighten the screw again.
SIM 2
SIM 1