New Air AW-320ED User manual

INSTRUCTION MANUAL
Thermoelectric Wine Cooler
MODEL: AW-320ED
Please read carefully and follow all safety rules and operating instructions.

Product Diagram
1.LIGHT 2.FANMASK 3.SHELF 4.FOOT
5. HINGE 6.TEMPERATURE DISPLAY 7.TEMPERATURE CONTROLLER
8.DOOR FRAME 9.GLASS DOOR 10.HANDLE
Important Safety Instruction
zRead all instructions before operating the wine cooler.
To reduce the risk of fire, electrical shock, or injury when using
your appliance, follows these basic precautions;
zATTENTION: To prevent the risk of child entrapment, do not allow children to operate, play
with, or crawl inside the unit.
zIf the unit will not be used for an extended period of time, remove the door, and leave the shelves
in place so that children cannot craw inside. Also remove the door when disposing the unit.
zNever clean the appliance parts with flammable fluids, as the fumes can create a fire hazard or
explosion.
zDo not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or
any other appliance, as the fumes can create a fire hazard or explosion.
zDo not store food in the wine cooler, as the interior temperature will not be low enough to prevent
food spoilage.
Please Save These Instructions

Installation Instruction
Before using your wine refrigerator
zRemove the exterior and interior packaging.
zCheck to make sure the following parts are included:
914 slide-out shelves
91 instruction manual
zBefore connecting the unit to a power source, allow it stand upright for approximately 2 hours.
This will reduce the possibility of any system malfunctions which may have occurred from
handling during transportation.
zClean the interior surface of the unit with lukewarm water and a soft cloth.
zPlace the wine cooler on a leveled surface that will be strong enough to support the unit when it is
fully loaded. To level your wine cooler, adjust the front feet located at the bottom of the unit.
zInstall the wine cooler away from direct sunlight and heat sources such as stoves, heaters, or
radiators, as direct sunlight may affect the unit’s acrylic coating, and nearby heat sources can
increase electrical consumption. Moreover, extreme cold or hot ambient temperatures may also
prevent proper performance.
zPLEASE NOTE: This wine cooler is only designed for home use, and is not designed to be
placed in a garage or basement.
.
Electrical Connection
To ensure safety and proper operation, please follow the guidelines listed below:
Warning
Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by an authorized Products service center.
•This wine cooler should be properly grounded for your safety, and in order to minimize the
possibility of electrical shock, the power cord of this unit is equipped with a 3-pin plug which
fits with 3-pin wall outlets.
•Never cut or remove the ground wire from the supplied power cord.
•The use of extension cords is not recommended.
•This unit requires a standard 110V-60HZ electrical outlet with a 3-pin plug. The cord should
be secured behind the wine cooler. Also, to prevent accidental injury, do not expose or dangle
the cord.

Operating Your Wine Refrigerator
It is recommended that you installed the wine refrigerator in a place where the ambient temperature is
between 10-26℃(50- 80°F) .If the ambient temperature is above or below recommended temperatures,
the performance of the unit may be affected. For example, placing in extreme cold or hot conditions may
cause interior temperature to fluctuate. The range of 10-16℃(50-60°F )may not be reached.
The temperature may fluctuate depending on whether or not the interior light is on or off or whether the
bottles are located on the upper, middle or lower section.
How to use the Buttons on the Display Panel:
The desired temperature and light can be set by pressing the buttons on the display panel. The two
buttons on the panel - “ ” and “ ” - adjust the temperature in increments of 1° C between 8-18° C
(46-66° F). You can also turn the interior light on or off by pressing the “ ” button.
Care And Maintenance
Cleaning Your Wine Cooler
zUnplug the wine cooler and remove any bottles.
zWash the inside of the unit with a warm water and baking soda solution consisting of approximately
2 tablespoons of baking soda to one quart of water.
zPull out the water box at the bottom and rinse.
zTo clean the outside of the unit, use a mild detergent and warm water.
Moving Your Wine Cooler
zRemove any bottles.
zSecurely tape down all loose parts located inside the unit.
zTurn the leveling feet up to the base in order to avoid damage.
zTape the door shut.
zBe sure the wine cooler stays in an upright position during transportation.

Troubleshooting
To troubleshoot your wine cooler, follow the suggestions below to address the most common problems
before seeking assistance from a service center:
PROBLEM POSSIBLE CAUSES
The wine cooler will not operate. •The unit may be plugged in using a different voltage.
Also, the circuit breaker may be tripped or there is a
blown fuse.
The wine cooler is not cold
enough.
•Check the temperature control settings, as the external
environment may require a higher setting.
•The door may be opened too frequently.
•The door is not closed completely.
•The door seal does not seal properly.
•The wine cooler does not have sufficient clearance.
The light does not work. •Contact the dealer or an authorized service center.
The wine cooler vibrates while
operating.
•Make sure the unit is leveled.
The wine cooler produces a lot of
noise.
•The unit may not be leveled.
•Check the fan.
The door will not close properly. •The unit is not leveled.
•The doors are reversed and not properly installed.
•The seal is weak.
•The shelves are out of position.
The LED display does not work. •There may be a problem with the main control board.
•There is a PCB problem.
•There is a problem with the plug.
There is an LED display error. •The display may be weak.
•The temperature point is off.
The buttons do not function. •The temperature control panel may be damaged.