New Works 20612 User manual

Assembly & Care Guide
Lantern Wall Lamp
[email protected] Frederiksgade 1, Ground Floor, 1265 København DK www.newworks.dk
e Lantern Wall Lamp is carefully made and therefore every item is unique.
It may occur dierent expression in the material and surface, with smaller marks and minor deviations.
SAFETY INSTRUCTIONS
Please read the instructions carefully and retain it for future reference. New Works Aps is not responsible for any
faults or damages caused by not following the instructions correctly.
Turn o electricity at main circuit breaker panel before beginning the installation. Warning all wires are connected
- when unpacking the box, be careful not to pull wires, as this may result in a bad connection.
Dierent wall materials require dierent types of ttings. Always choose screws and plugs that are specially suited
to the wall material.
e lamp is only intended for indoor use, consult a professionally qualied electrician if any doubt.
Follow the guidance 220-240V~ 50/60Hz - E14 LED Max 7W or E14 Max 25W, (Bulb not included)
e light bulb and lamp exterior may get hot after prolonged use.
Turn o the power (unplug from wall outlet) before replacing the bulb. Make sure the bulb has sucient time to
cool down. Do not subject the lamp to any shock as this may cause the lamp to brake.
Keep the product out of children’s reach. Dispose the packaging and do not allow children to play with it.
Do not modify the product in any way.
CLEANING
Turn o the electricity before cleaning the lamp. Wipe the lamp exterior with a soft dry or moist cloth. Do not use
any abrasive cleaning tools, and never use strong cleaning agents such as household glass cleaner, white spirit or
turpentine.
MORE INFORMATION
For more information such as product overview, material description and disclaimers - please visit our website at
www.newworks.dk for further information. If you have any questions or comments, please do not hesitate to con-
tact us at [email protected].

Assembly & Care Guide
Lantern Wall Lamp
[email protected] Frederiksgade 1, Ground Floor, 1265 København DK www.newworks.dk
ASSEMBLY INSTRUCTIONS
1. Draw a straight vertical line on the wall indicating where to place the wall tting.
Mark the rst screw hole on the vertical line 3,5 cm from centre and up.
2. Place the lamp base (B) above the wall tting and turn it 60˚ clockwise to lock.
3. Lock the base secure by using the Hex-key (C) Included to tighten the set screw (D) placed on the top right side.
4. Install the light bulb, E14 LED Max 7W or E14 Max 25W (not included)
5. Mount the glass shade (E)
(A)
(B)
60˚clockwise
(E)
(C)
(D)
Read the instruction carefully and turn o electricity at main circuit breaker panel before beginning the installation.
Warning all wires are connected - when unpacking the box, be careful not to pull wires, as this may result in a bad
connection. Do not connect the electricity until the lamp is fully assembled.