Assembly
Assembling the Reindeer and Sleigh
Step 1.Insert the metal rods attached to the each Leg (F&G) into the matching holes on the
underside of the Body (D).(FIG.1)
Step 2. The Legs come with metal bars attached to stabilize the Deer. Insert the hooked end
of the metal bars into the metal nut on the opposite Leg.Insert the rod of Tail (E) into the rear
of the Body(D). (FIG.1)
Step 3.Insert the Head (A) into the matching holes in the body.Insert both Antlers and Ears
(C&B) into the matching holes at the top of Head (A).(FIG.1)
Step 4. Insert two rods of each quarter of lower Runners (M) into the matching holes in the
neighboring runners.The Runners come with metal bars to stabilize the Sleigh.Insert the rod
of Half circle(N) into the matching hole of the higher Runners (M) .(FIG.2)
Step 5.Insert two rods of each quarter of Side Panels (L) into the matching holes in the
neighboring Panels of Sleigh.Insert the rods of the side of Panel (L) into the matching holes
of the Runner (M).(FIG.2)
Step 6.Insert the rods of the Front and Back panel(H&J) into the matching hole in the Seat
Pane(I).Unfold the Interior Panel (H&I&J). Insert the rods of the Interior Panel into the matching hole at
the each side of Side Panel (L).Attach the bars to the opposite side runner and fasten them with Nylon
Tie (P).(FIG.2)
Step 7.Insert the wires of the Bow Tie(K) through the holes of the body then twist the
wires together to secure. Fasten the Deer and Sleigh with Nylon Tie(P).(FIG.3)
Step 8.Secure the Deer and Sleigh to the ground with the Ground Stakes (O).( FIG.3)
Pre-Operation
CAUTION:Grasp the plug to insert or remove from the power source.
Do not unplug by pulling on cord.
CAUTION:The lighting string on this product is rated at 9.6 Watts
(0.08 Amps) for Reindeer and rated at 7.2 Watts (0.06Amps) for Sleigh. Do not
connect to another lighting string, decorative outfit or other product. Before you use
or re-use this product, inspect it carefully. Discard if the product has cuts, damage,
frayed wire insulation on cords, cracks in the socket enclosures, loose connections
or exposed copper wire.
CareandCleaning
a. Carefully remove the product from wherever it is placed. This helps to avoid any
undue strain or stress on the product, wire and lighting connections. If the product is
placed somewhere other than the ground it should be well secured and stable.
b. Wipe the product with a damp cloth and allow the product to dry before storing.
c. Store the product neatly in a cool, dry location protected from sunlight.
FOR INDOOR AND OUTDOOR USE
FIG.3
FIG.1 FIG.2
C
A
D
F
E
G
B
H
I
J
L
N
M
K
