New Works Ware User manual

Assembly & Care Guide
Ware Table Lamp
[email protected] Frederiksgade 1, Ground Floor, 1265 København DK www.newworks.dk
e Ware Table Lamp is carefully made and therefore every item is unique.
It may occur different expression in the material and surface, with smaller marks and minor deviations.
SAFETY INSTRUCTIONS
Please read the instructions carefully and retain it for future reference. New Works Aps is not responsible for any
faults or damages caused by not following the instructions correctly.
e lamp is only intended for indoor use, consult a professionally qualified electrician if any doubt.
Follow the guidance 220-240V~ 50/60Hz - E14 LED Max 7W, Dimmable Bulb Only. (Bulb not included)
e light bulb and lamp exterior may get hot after prolonged use.
Turn off the power (unplug from wall outlet) before replacing the bulb. Make sure the bulb has sufficient time to
cool down. Do not subject the lamp to any shock as this may cause the lamp to brake.
Keep the product out of children’s reach. Dispose the packaging and do not allow children to play with it.
Do not modify the product in any way.
CLEANING
Turn off the electricity before cleaning the lamp. Wipe the lamp excterior with a soft dry or moist cloth. Do not
use any abrasive cleaning tools, and never use strong cleaning agents such as household glass cleaner, white spirit, or
turpentine.
MORE INFORMATION
For more information such as product overview, material description and disclaimers - please visit our website at
www.newworks.dk for further information. If you have any questions or comments, please do not hesitate to con-
tact us at [email protected].

Assembly & Care Guide
Ware Table Lamp
[email protected] Frederiksgade 1, Ground Floor, 1265 København DK www.newworks.dk
Read the instruction carefully and turn off electricity at main circuit breaker panel before beginning the installation.
Warning all wires are connected - when unpacking the box, be careful not to pull wires, as this may result in a
bad connection. Do not connect the electricity until the lamp is fully assembled. Unpack and place all parts on a
levelled and stable surface.
ASSEMBLY INSTRUCTIONS
1. Place the lamp Base (A) on a flat surface.
2. Take of the front shell and install light bulb (B) (Not included)
3. Place the front shell back on again (C)
4. Connect to electricity outlet
Note: e lamp has a three-step touch dimmer placed on the backside of the lamp.
(A)
(B)
(C)