Nexo LNI-3L15 User manual

PAGE 1 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
LNI-3L15
DP5820 –01c - DI
Up to 3xL15 Rigging System
Contents:
X1 Ceiling Plate
X4 L15 Plate
X2 Main Plate
X6 M10x30 (a)
X12 M10x20 (a)
(a): The type of the screws may differ from the representation
Weight: 22.5 kg / 49.5 lb

PAGE 2 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
Dimensions:
For fixation, you have the choice between M8 and M10 (Fasteners not included)
WARNINGS
Ensure that the mounting location and fasteners can support at least 4 times the weight of all the installed cabinets, auxiliary
equipment and cables.
Use only the provided screws (thread lock coated) and accessories.
Implementation of L15
Prepare the Main plates by screwing the M10x30 screws on the holes (see picture below), do not tighten completely and leave
at least 6mm.
Assemble the L15 Plates on each side of L15 using the M10x16 screws.
CARDIO mode
OMNI Mode



















PAGE 3 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
Assembly on the ceiling plate
Place the assembly below the ceiling plate.
Tighten the screws. Secure with the 2 provided M10x30 screws.
LNI-3L15 frame tilt (+/- 1°)
Holes 1
Holes 2
Holes 3
Holes 4
Holes 5
Holes 6
Holes 7
Holes 8
Holes 9
2x L15
11°
9°
5.5°
3°
0°
-2°
-4.5°
-7°
-10°
3x L15
8.5°
7°
4.5°
3°
1°
-2.5°
-3.5°
-6°
-7°
Note 1 : Holes 1 are those toward F.O.H.
Note 2 : All angles measurements have been done without cables weight.
Note 3 : Angles are in relation to Horizontal position ( 0° )

PAGE 4 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
•NEXO cannot accept responsibility for accidents caused by any factor other than defects in this product itself.
•Please check the web site nexo-sa.com for the latest update.