NEXTLED NT-6926 User manual

Model NT-6926
Rechargeable, Dual Head
LED Work Light
with Telescoping Tripod
The NextLED Rechargeable, Dual Head LED Work Light with
Telescoping Tripod is designed to meet a wide variety of lighting
applications. Super bright, up to 5,000 lumens on high power,
1,500 lumens on medium power and 500 lumens on low power, it
offers both bright white and daylight modes of operation for all three
settings. It has two power options; rechargeable battery for shorter
duration use and corded for extended duration use. With its easy
and infinite adjustment options, it can place light exactly where you
need it. The tripod base fully extends to 75.5” and folds compactly
to just 35” for convenient transporting and storage and features
tough, lightweight aluminum construction. Includes two lithium ion
rechargeable batteries and charging cable.
CAUTION:
Read all instructions and warnings before operating!
SAVE THESE INSTRUCTIONS!
WARNING: To avoid serious injury or death from electrical shock or fire:
1. This fixture MUST ALWAYS BE USED IN ACCORDANCE WITH ALL
ELECTRICAL AND SAFETY CODES AND ORDINANCES, including
the most recent National Electric Code (NEC) and with the
Occupational Safety and Health Act (OSHA) Volume 1 on General
Industry Standards and interpretations.
2. ALWAYS make certain that the power source conforms to the rating
on the fixture.
3 DO NOT inspect or service the fixture while charging.
4. CAUTION: This fixture is for indoor use. Keep dry. Do not open,
drop, short-circuit, incinerate, expose to temperatures higher
than 140ºF, or charge/use if damaged.
5. People with pacemakers should consult their physician(s) before
use. Electromagnetic fileds in close proximity to heart pacemaker
could cause pacemaker interferance or pacemaker failure
6. This fixture is not explosive-proof, DO NOT use in potentially
dangerous locations, such as in flammable or explosive
atmospheres.
7. NEVER operate the light with the clear protective glass
broken or removed.
8. NEVER LOOK DIRECTLY INTO LIGHT SOURCE. LED’s are extremely
bright and can damage eyes with prolonged exposure.
9. KEEP AWAY from heating vents, radiators, or other sources of heat.
10. KEEP OUT OF REACH OF CHILDREN.
MAINTENANCE
Only qualified service personel must perform repairs. Opening or
visible attempts to open or repair work light will void any warranty
and/or cause damage to the product or personal injury.
CAUTION! Do not use solvents such as gasoline,
turpentine, etc. to clean the unit. Aerosols and other
chemical will fog the clear polycarbonate lens.
LITHIUM BATTERY SAFETY WARNINGS
LITHIUM BATTERIES STORE A LARGE AMOUNT OF ENERGY AND
WILL VENT FIRE OR EXPLODE IF MISTREATED:
1. Keep work light dry.
2. DO NOT DO ANY OF THE FOLLOWING TO BATTERY PACK:
a. Drop d. Puncture
b. Open e. Incinerate
c. Short-circuit f. Expose to temperatures
greater than 140ºF.
3. Charge work light only according to these instructions
BATTERY OPERATION
1. Press the lower power button to turn on the
LED light to the lowest illumination setting
of 500 lumens.
2. Press the lower power button again quickly,
to brighten the light to the medium setting
of 1,500 Lumens.
3. Press the lower power button a third time
quickly, for the full power of 5,000 Lumen
LED lights.
4. Press lower power button a final time to turn the light off.
CORDED OPERATION
1. Press the lower power button to turn on the LED light to
1,700 lumens.
2. Press lower power button a final time to turn the light off.
TO ALTERNATE BETWEEN BRIGHT WHITE LED
AND DAYLIGHT LED
1. Press the lower Power button to your
desired illumination level.
2. Press the upper lighting selection button
to alternate between the Bright White
LED light setting and the Daylight
LED setting.
TRIPOD SETUP
1. Unlatch the top release lever to loosen.
Slide the top portion to desired height and
lock into place.
2. Unlatch the bottom release lever to loosen.
Slide the bottom portion to desired height
and lock into place
Tips & Tricks: If the latch is too loose or
too tight, we have designed a standard
Philips screw allowing you to slightly tighten
or loosen the latch locking tension to your
desired setting.
3. To set up legs, simply pull each of the three
legs downward, until they automatically lock into place.
4. Unlatch the top release lever to loosen the top bar. Now, the
top tripod bar is fully rotatable for 360 degree LED positioning,
without needing to move the legs

TRIPOD STORAGE
1. Unlatch the top release lever to loosen. Slide
the top portion downwards fully closing the
top portion of the unit.
2. Unlatch the bottom release lever to loosen.
Slide the bottom portion downwards fully
closing the bottom portion of the unit.
3. To fold up the legs, simply slide the release
lever downwards to unlock the pin that is
holding the leg in place. While sliding the
release lever down, begin pulling up on the
leg to fold it all the way upwards until snug.
Tips & Tricks: Our legs are designed for stability and you may
need to gently pull up or down on the leg to align and disengage
the locking pin. If you pull too hard the pin could be damaged
and not algin properly.
REMOVEABLE LED HEAD
The LED head can screw off at the top by
simply rotating the head unit. Once loosened
the head will come off.
1. Once it is detached the LED head can sit
on the ground or it can be attached to any
magnetic surface.
2. This LED head comes equipped with 4
strong magnets, that are attached to the base of the LED head.
3. The LED head comes standard with a protective dust cap,
covering the charging plug interface.
BATTERY CHARGING
NOTE: Both lights must be charged together.
1. Remove the protective dust cap, then
connect the power cord adapter into the
underside of the LED, where pin adapter
inserts.
Tips & Tricks:
To Insert: you must fully insert the power
cord adapter until you hear an audible click
to let you know it is fully inserted.
To Remove: Turn the power cord adapter
counterclockwise to unlock and remove
from the unit.
2. Connect the plug end of the charger into
an electric outlet.
3. AC/DC DUAL POWER MODE: The LED light
will be fully operational as long as the power
cord is plugged into the wall (even if the
batteries are not charged).
Battery Charging Indicating:
4 blue lights on the unit will light up and blink
as it is charging.
When lights are fully light up, the unit is fully charged,please unplug
the adapter.
WARNING! Charge while indoors only.
WARNING! Always use the 8.4v / 3A charging cable and adapter
that came standard with your unit
Using a non-compatible charger could cause damage to the work
light or personal injury.
Your product, accessories and packaging should be discarded in an
environmentally responsible way.
Illustrations, figures and photos may vary slightly due to our program
of continuous product improvements.
Cancer and Reproductive Harm
www.P65Warnings.ca.gov
ONE YEAR LIMITED WARRANTY
If this NextLED®product fails due to defect in materials or
workmanship, NextLED®will at its option, repair it or replace it
with the same or comparable model, free of charge.
For repair or replacement under warranty, return to the retail
establishment where the product was purchased.
This warranty give you specific legal rights and you may have
other rights that vary from state to state.
This warranty is void if damage or defect has resulted from accident,
abuse, misuse or faulty repair. In no event will NextLED®be liable for
any consequential, special, incidental, or indirect damages of any
kind arising out of the use or misuse of this product.
Maximum liability shall not in any case exceed the purchase price
of the product including shipping. Some states do not allow the
exclusion or limitation of incidental or consequential damages so the
above exclusions or limitations may not apply to you.
© 2021 Distributed by Nextool Inc.
Schaumburg, IL
Visit www.mynextled.com
Customer Service: 1-877-886-6822
V2
MADE IN CHINA
SPECIFICATIONS
LED’s: ..........................Two Illumination settings:
White & Daylight) SAMSUNG 2828
White & Daylight)
Max. Brightness ..........5,000 Lumens (High)
(Battery): 1,500 Lumens (Medium)
500 Lumens (Low)
Max. Brightness .........1,700 Lumens
(Corded):
Runtime: ......................1 hr. (High) / 2.5 hrs. (Medium)/ 7 hrs (Low)
by fully charged battery
Battery Size: ................Two rechargeable Lithium-Ion
Batteries included; 7.4v 4000 mAh
Functions 2 ways: .......cordless with batteries and also
works while plugged into an outlet.
Charger:.......................8.4V / 3A
Rechargeable
Charging Cable ...........Included
Charging time: .............6 hrs (Charger: 8.4V / 3A)
Net Weight:..................9.9 lbs.
Tripod fully extends to 75.5” and folds down to just 35”
Scan to register
your product
Simply scan and register
your product for warranty
or visit www.mynextled.com.