0478-0111-02
1 Safety information
2 Introduction
This document covers Retro mounting instructions for Unidrive M600 /
M70X, F300, H300, E200 & E300 size 6 drives.
The Retro Mounting Kit is used for replacing the Unidrive SP size 3 with
a Unidrive M size 6 without any modification to the backplate.
The following items are supplied in the kit bag:
Table 2-1 Contents of the bag (CT Part Number: 3470-0074-00)
The following items are included in the kit boxes 3470-0054 and
3470-0037, either of which can be supplied with the drive.
Table 2-2 Additional items required
2.1 Installation instructions
Figure 1-1 Installing the brackets
1. Secure the upper Retro fit mounting bracket to the backplate using 1
x M6 suitable fastener (1), and 1 x countersunk screw (2), and
tighten to a maximum torque of 3 N m (26 Ib in).
2. Position the bottom mounting bracket (supplied with the drive) and
loosely fit the bracket using 2 x M6 suitable fasteners (not supplied). Do
not fully tighten to the backplate at this stage.
Figure 1-2 Locating the drive to the bottom mounting bracket
Offer the drive up to the lower mounting bracket at a slight approach angle.
Unidrive M600-M70X, F300, H300, E200 & E300
Size 6 Retro Mounting Kit Installation Sheet
Follow the instructions
The mechanical and electrical installation instructions must
be adhered to. Any questions or doubt should be referred to
the supplier of the equipment. It is the responsibility of the
owner or user to ensure that the installation of the drive and
any external option unit, and the way in which they are
operated and maintained, comply with the requirements of
the Health and Safety at Work Act in the United Kingdom or
applicable legislation and regulations and codes of practice in
the country in which the equipment is used.
Competence of the installer
The drive must be installed by qualified personnel who are
familiar with the requirements for safety and EMC. The
installer is responsible for ensuring that the end product or
system complies with all the relevant laws in the country
where it is to be used.
Description Image Qty
Retro fit mounting bracket 1 x 1
M6 x 12 Double sem torx screw x 2
M6 x 16 Countersunk screw x 1
Retro mounting kit installation
sheet x 1
Description Image Qty
Frame 6 mounting bracket x 1
