7
Troubleshooting
No heart rate displayed on watch:
he grooved sensors may not be wet enough.
Wet and try again. It is recommended that you wear
the Heart Rate ransmitter directly against your skin.
If you are wearing the HR ransmitter over clothing,
try getting the clothing wet also.
he HR ransmitter may not be positioned correctly.
Make sure the grooved sensors are flat against the skin.
Heart rate reading on watch is erratic or stops:
You may need to replace the battery in the HR ransmitter .
Sources of electromagnetic fields like appliances,
computers and power lines can cause interference.
Change your location.
This product complies with EN60601-1-2
Watch display is frozen:
he display of your watch may "freeze" due to static
electricity or recent battery replacement. If this occurs,
press and hold both buttons at the same time.
his will erase the data in the memory and allow you
to reset the watch to the factory settings.
Specifications
IP code: IPX8
Applied Part: ype CF
Storage: Standard Conditions (within operating temperature)
Watch
Water Resistant p to 30 Meters:
Designed for underwater performance
to a depth of 99 feet (30 m).
ATTENTION: Water damage
will occur if watch buttons
are pressed while underwater!
Operating Temperat re: -5 to 50˚ Celsius
Material Specifications:
Crystal: Mineral Glass
Case: Polycarbonate
Buckle: Stainless Steel
Bezel: Stainless Steel
Caseback: Stainless Steel
Strap: Polyurethane
Mode Limits:
Chronograph: 23:59’59”
Heart Rate: 30 - 240 bpm
Heart Rate Transmitter
Water Resistant p to 30 Meters:
Wipe dry after use. Do not store among conductive material.
Operating Temperat re: -5 to 50˚ Celsius
Acc racy: +
-1% or +
-1% bpm, whichever larger (steady state)
Material Specifications:
Case: Polycarbonate
Strap: Urethane
Band: Elastic
Press and hold both buttons
at the same time to reset
the watch to the actory settings.