Magene H603 User manual

H603 Heart Rate Monitor
Model:H603

·Do not disassemble, modify, puncture, or damage the
device or the battery.
·Do not expose the device or the battery to fire, explosion,
or other hazards.
·Do not place or store the device near a dryer, in a car
under direct sunlight, or in other high-temperature
environments.
·Do not immerse the battery in water or other liquids.
·Do not use any sharp object when removing the button
cell battery.
·Keep the battery out of reach of children. Swallowing the
battery may cause chemical burns, soft tissue perforation,
or even death. Seek immediate medical help if the battery is
swallowed.
The product uses a CR2032 button cell battery.
Failure to follow the instructions listed below may
shorten the battery's shelf life, damage the device, or
cause fire, chemical burns, battery leakage, or the risk
of injury.
The heart rate sensor monitors your heart rate during
sports. It supports ANT+ and Bluetooth wireless
protocols, allowing you to send heart rate data to a
mobile app, bike computer, sports watch, or any other
smart device that supports standard ANT+ and
Bluetooth protocols. By recording each and every
heartbeat, it enables scientific and pleasant training.
Safety Warnings and Product Information
Our Product
Warning
Failure to notice the potential dangers listed below
may lead to severe harm or even fatal accidents.
Battery-related warning
·If you are implanted with electronic devices in your body,
such as a pacemaker, consult your physician before using
the heart rate sensor.
·Data on the heart rate sensor is for reference only and
cannot be used for the medical diagnosis, monitoring,
treatment, or prevention of any disease. Magene is not
responsible for the consequences of any data error.
Health-related warnings
②Rotation position for the battery holder
①Snaps of heart rate sensor electrodes
2

*To avoid errors in the collected heart rate data, make
sure to place the heart rate sensor in the proper
direction. Wear the heart rate monitor directly on your
skin, just below your chest. It should be snug enough to
stay in place during your activity
2. Align the buckle on the left side of the sensor with the
mother buckle on the chest strap.
Wearing the Heart Rate Sensor
3
1. Wet the electrode areas on the reverse side of the
strap.
4. Align the buckle on the right side of the sensor with
the female buckle on the chest strap, and the electrode
is close to the skin.
Placement Illustration for Men Placement Illustration for Women
5.After the sensor is properly worn, it will automatically
turn on, the front LED flashes (turns off after 10 times),
select the correct ANT ID or Bluetooth ID on the bike
computer, watch, and APP, and the heart rate data will
be transmitted
3. Wrap the chest strap around your chest and adjust
the length to a comfortable position.
LED
ANT ID、Bluetooth ID
20136-169

Opening position
Locking position
Pairing the heart rate sensor with an ANT+ device
Wear the heart rate sensor before you can pair it with
a compatible device.
Keep the sensor within 3 meters of the device to be
paired and over 10 meters away from other ANT+
devices.
When the initial pairing is complete, the compatible
device will automatically identify the enabled sensor.
Pairing the heart rate sensor with a Bluetooth device
Wear the heart rate sensor before you can pair it with
a compatible device.
Keep the sensor within 3 meters of the device to be
paired and over 10 meters away from other Bluetooth
devices.
The sensor cannot be found by directly using
Bluetooth on a phone and can only be connected to a
Bluetooth device or an app at the same time.
When the initial pairing is complete, the compatible
device will automatically identify the enabled sensor.
1. Use a coin to rotate the arrow mark on the battery
cover anticlockwise from the locking position to the
opening position. You can then open the battery
holder.
2. Remove the used battery.
3. Place a new battery into the battery holder. Align
the arrow mark to the opening position and press
down the battery cover (see figure below). After
pressing the whole cover into the battery holder, use
a coin to rotate the arrow mark clockwise to the
locking position.
*You may have to re-pair the heart rate sensor after
battery replacement.
Pairing and Settings
Battery Replacement
4

Note:
·A buildup of too much sweat and salt on the strap can
decrease the accuracy of the data measured by the
heart rate sensor.
·Wash the strap with clean water after every use.
·Do not put the strap into a washing machine or dryer.
·Please air-dry the strap by hanging it or laying it flat.
Maintenance of the Heart Rate Sensor
5
2. Follow the instructions below if heart rate data is
abnormal or not displayed.
·While wearing the heart rate sensor, check if the LED
light is flashing. If not, replace the battery.
·Wet the electrodes on the strap and adjust the strap
length to fit tightly.
·Please wear cotton clothes. The static electricity
created by artificial fibers will interfere with heart rate
signals.
·Stay away from environments that may affect the
heart rate sensor.
3. What sports during which I can use the heart rate
sensor?
The heart rate sensor can be used during sports such
as cycling, running, and fitness. It cannot be used while
swimming.
4. Why I get a "Pairing rejected" message or data is
not displayed when I connect the heart rate sensor to
Bluetooth on my phone?
The heart rate sensor only supports searching and
connecting via a sports app if you wish to connect it to
your phone. The sensor cannot be connected directly
through Bluetooth on the phone.
FAQs
1. What apps, bike computers, and sports watches are
the heart rate sensor compatible with?
The heart rate sensor can be connected to apps of
peripheral, bike computers, and sports watches that
support standard Bluetooth or ANT+ protocols.
5. How long does the heart rate sensor's battery life
last ？
1000 hours battery life.

Specifications
Heart rate range
Battery type
Battery shelf life
Wireless transmission protocol
Operating temperature
Protection rating
Weight
Sensor dimensions
Strap length
30~240BPM
3V CR2032 button cell
1000 hours
Ant+ and Bluetooth
-10℃~50℃
IP67
16g
62.3*35.1*11.5mm
64~86cm(±2cm)
For more information, contact us:
Qingdao Magene Intelligence Technology Co., Ltd.
Website: www.magenefitness.com
After-sales support: [email protected]
6