Page9
Insert camera batteries
The D7000 body holds one battery. The MB-D11 holds one battery. The D700
will operate properly without the MB-D11. The MB-D11 extends operation
time. If the MB-D11 Battery grip is attached, it must be removed before
replacing the battery in the camera body. At the back of the MB-D11 is a wheel
labeled “lock”.
To remove the MB-D11 turn the wheel to the left and the battery grip will
separate from the camera body.
With the MB-D11 removed, the battery compartment on the D7000 is located
on the bottom of the camera. Move the battery compartment release toward the
middle of the camera and the battery door will open. With the door open, move
the yellow release until the battery pops up.
To install a battery, with the battery door open push the battery in until it snaps
in place. Close the battery door, and attach the MB-D11.
The MB-D11 holds one battery. To access the battery compartment pull the
release tab located on the side of the MB-D11. With the tab straight out turn the
tab in direction of the green arrow. The battery compartment will slide out and
expose the battery. To release the battery, push on the tab labeled “push” and
the battery will slide free. To install a battery, slide the battery with the
contacts down until it snaps into place. Then slide the compartment into the
MB-D11 and turn the release tab to lock in place.
The MS-D11 also has a accessory that replaces the rechargeable battery
compartment with one that holds 4 AA batteries. Observe proper polarity when
installing batteries. The compartment slides in place in the same manner as the
standard rechargeable one. Photos on page 5
