ALWAYS ROLL UP PANELS WITH FABRIC
FACING FABRIC AND MAGNET FACING
MAGNET.
1) Lay Panel Wrap logo down, with the Hook Tape side
facing up. Position the first panel approximately 24"
below the Hook Tape. All Panel hooks must be placed
at the end marked "A".
COMPACT AND CASE
TO COUNTER CONTENTS
2) Stack Panels largest to smallest & offset the panels by
approximately 3". Include the CCK2 door panel.
3) Roll up panels together within Wrap and secure with
Hook & Loop Tape.
Hook Tape
Off Set Panels By 3"
A
Approx. 24"
ROLL UP PANELS AND SECURE THE WRAP
USING THE HOOK AND LOOP TAPE
FASTENER.
Wrapped Panels
with CCK2 Door
Panel
LightCarton
CompactFrame
CounterTop
Counter Base
Case-to-Counter
Outer Panel
Protective Bag for
CounterTop
ChannelBars
Place the CounterTop in the
Protective Bag,then place
it in the case along the side
opposite the door.
PACKING INSTRUCTIONS
Pack the Frame next to the
ChannelBar holder.
Place the wrapped Panels
between the Counter Base and
CounterTop.
Roll up the Case-to-Counter
Outer Panel. Secure it
with rubber bands &
insert it in the center
of theWrapped Panels,
into the well in the
bottom of the case.
Slide the Light
Carton between the
Frame and Counter Base.
1.
2.
3.
5.
Refer to front Cover for packing diagram.
4.
CCK2 Door Panel
Insert Channel Bars upright into the holder
in the bottom of the case.
Slide the Counter Base into
the case along the door side.
