NOBEL HOUSE BAR TABLE User manual

Label Picture Description QTY
A Table Top 1
B Table Leg B 2
C Table Leg C 2
D Side Stretcher 2
E Cross Bar 1
Assembly Instructions
Caution : You must read this before you proceed
BAR TABLE
Part List
Page 1 of 6

Label Picture Description QTY
①
JCBB M8 x 70mm
+ S/W 5/16"
+ F/W 5/16" x 22mm
8
②Allen Key M5 1
③
JCBC M6 x 45mm
+ S/W M6
+ F/W M6 x 13mm
2
④Allen Key M4 1
⑤FH SCREW #8 x 32mm 4
Before
Beginning
Assembly:
Assembly Preparation
Hardware
Page 2 of 6

Step 1
Assembly Steps
Overview
This Bar Table has multiple parts and may require up to some 30 minutes to
assemble. To give you an overview of the Bar Table parts, the above picture
is to help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before
assembly.
Place the Table top (A) on a soft surface to avoid any scratches or damages
to the product and place the Table Leg (B) onto the of table top corner block
with your adult partner. Table Leg (B) has a small hole identification.
Fix the Table Leg (B) with JCBB Bolt ① + Spring Washer + Flat Washer
using Allen Key ②.
Repeat the step for Table Leg (C) as shown.
DO NOT FULLY TIGHTEN THE BOLT.
Table Top
Table Leg(B)
Table Leg(C)
Table Leg(C)
Table Leg(B)
Side
Stretcher(D)
CrossBar(E)
TableLeg(B)
hasasmall
holefor
identification
Page 3 of 6

Step 2
Step 3
Place the Cross Bar (E) with Side Strecther (D) as shown.
Then, fix the Cross Bar (E) with JCBC Bolt ③ using Allen Key ④.
DO NOT FULLY TIGHTEN SCREWS.
Place the Assembled part that finished on step 2 onto the mounting position
of the Table Leg.
Then, slot in the another Table Leg (B) and (C) on the Side stretcher
mounting position.
Page 4 of 6

Step 4
Repeat step 1, Fix the Table Leg (B) and (C) with JCBB Bolt ① + Spring
Washer + Flat Washer using Allen Key ②.
Fix the Side Stretcher (C) with CSK Screw ⑤ using Screwdriver (not
provided).
In case the table wobbles, need loosen tighten the screw and bolts, and use
your hand press the top of the table, to make sure the table eveness, and
then full tighten the bolts sequence.
FULLY TIGHTEN THE BOLT.
With assistance from your adult partner, stand the Table up.
Your Table is now ready for use.
Page 5 of 6

Care & Maintenance
Page 6 of 6