Furniture of America Glenview CM8372BK-T User manual

1. Place the glass top (#1) face
down onto a protected surface.
Align three leg stands (#2) to the
holes along the glass top (#1).
Insert a bolt (#B) into each hole.
Secure using the Allen wrench (#F).
2. Align the leg support frame (#3) to the holes along
the center of the leg stands (#2). Insert 2 bolts (#B)
into each end. Secure using the Allen wrench (#F).
Slide the shelf (#4) face down
under the leg support frame (#3).

1. Align the fourth leg stand
(#2) to the holes, then insert
a bolt (#B) into the bottom
hole and 2 bolts (#B) into
the holes along the leg
support frame (#3). Secure
using the Allen wrench (#F).
3. Place the plastic
gaskets (#H) onto
the bottom ends
of the leg stands.
2. Prepare 4 screws by inserting a
flat washer (#G) onto the screws
(#C), then lift and align the shelf
(#4) to the leg support frame (#3).
Insert a screw assembly into each
and secure using a screwdriver.
1. Place the base (#5) face down onto the leg stands (#2). Prepare 8 bolt assemblies by inserting
a flat washer (#E) onto the bolt (#A). Insert into the holes and secure using the Allen wrench (#F).
2. Align the base support rail (#6) to the holes along
the center of the base (#5). Insert a screw (#D) into
each hole and secure using a Phillips screwdriver.

Turn the table upright and make sure all parts are firmly secured.
ASSEMBLY IS COMPLETED