Tanova TBT30-212 User manual

For Models
TBT30-210
TBT30-212
Installation Guide
Your Handy Step By Step
For further assistance in New Zealand
www.tanova.co.nz 0800 852 258
For further assistance in Australia
www.tanova.com.au 1300 123 700

2
Parts Check List
Identify parts shown in images and screw
pack components listed below.
• 20 x 8g x 15mm pan head screws for
fixing top cover into cabinet
• 10 x M6 x 11mm Euro screws to fix
runners to cabinet
• 6 x 6g x 15mm countersunk screws
to fix drawer front connectors and
gallery rails
• 2x Front connectors
• 2x Gallery rail expansion dowels
• 2x Drawer side cover caps
Tanova TBT Series Installation
Space Required for Installation
Model W H D
TBT30-210 267 365 510
TBT30-212 267 365 510

3
1.
With your cabinet on its side (fig1) mark
fixing positions with a pencil (see page 8).
Using a 5.0mm drill pre-drill the runner
fixing holes.
Fig. 2
Fig. 1

4
2.
With cabinet upside down, fix top cover
frame into cabinet as demonstrated in
(fig 3). Front edge of top cover to be
3.0mm from front cabinet edge. Use the
8g x 15mm pan head screws supplied
and screw to cabinet to before fixing to
the sides.
3.
Remove runners from drawer side as
shown on page 6 using the release tabs
in the side of the drawer, hold these
forward while extending the runner out
the back of the unit and then give a sharp
pull to disengage from drawer.
Using the euro screw provided fix the
runners to the cabinet sides in the
position shown in (fig 4) utilising
pre-drilled 5.0 fixing positions.
Fig. 4
Fig. 3
4.
Place cabinet back in upright position &
insert drawer chassis carefully. Slide back
into cabinet and push firmly into place
until you hear a click as the chassis locks
into position on the runners.
Fig. 5

5
5.
Using the dimensions shown in
(fig 6), mark and fit the front connectors
and gallery rail end plugs.
17
Fig. 6A
Fig. 6
Marking jig codes:
• RMD.91230 Drawer
front connector
marking jig
• RMD.92130N Gallery
rail marking jig
• If using marking jigs
see fig 7&8 on right
6.
Clip drawer front onto drawer
and locate gallery rails (fig 9)
and (fig 10). See (fig 9) to release
drawer front clips.
Model A B C
TBT30-210 153 128 32
TBT30-212 153 128 32
A
B
C

6
7.
Adjust drawer front as indicated below.
Drawer Front - Height and Tilt Adjustment
Drawer Removal
Drawer Insertion

7
8.
Once drawer front is adjusted fit the cover
caps as shown inserting the front tabs first
and clipping it into place.
9.
To increase stability lock off drawer front
using two pan head screws and fix through
two support points shown in (fig 12).
10.
Insert waste bin buckets or laundry basket
and you’re ready to go!
11.
Bags can be fitted (optional), just raise
handles and place bag liner in bin and
around the rim, now lower handles to hold
bag open and firmly in place.
Fig. 11
Fixing points for extra strength
Fig. 12

327.5311.0
TBT30-210 TBT30-212
TANOVA WASTE RUNNER
DRILLING SPECIFICATIONS
224.0 192.0 37.032.0
CABINET FRONT EDGE
MEASURE FROM UNDERSIDE OF CABINET TOP
TBT SERIES
F
ixing
Positions