Norvado IS-5041 User manual

IS-5041 Self-Install Guide
Replacement STB Installation
To ensure the successful installation of your IS-5041 Set Top Box, please read and
follow the step-by-step instructions below.
Do ou hae all the necessar equipment?
IS-5041 Set Top Box
Remote Control (this RC is already programmed to operate your STB. Instructions on how to
program your remove to operate your TV or other devices are available upon request.)
HDMI Cord
Power Cord
Poer Cord HDMI Cable

1. Make sure our T is turned off.
2. Connect the HDMI Cable from the HDMI port on the back of the STB to the
HDMI input on our T.
3. Turn on our T. Make sure that our T is set to the proper input.
4. Plug one end of the STB poer cord into the STB, and the other end into the
poer outlet.
5. As the STB starts up, it will displa the following message: No network
connection. Make sure the network cable is connected or press OK to begin Wi-Fi
WPS.
6. At this point ou are no going to connect our ne STB to our WIFI
access point. Press OK on the remote control to start the association process
on the ne STB. ou will no see the following message on the T:
Connecting to WIFI... Press the WPS button on your wireless access point.
7. Go to our WIFI access point (router) and start WPS.
8. In a fe seconds, the ne set top box should indicate that it has
connected with the following message: Wi-Fi connected. Waiting for
network setup.
9. As our STB loads, ou will see a elcome screen indicating the STB is
loading.
10. Once the STB has loaded ou are read to stream. Enjo our Norado TV!