NPD 3900076 User manual

ASSEMBLY INSTRUCTIONS
3900076 DINING CHAIR
Parts#
Parts Name
Drawing
Qty
1
Backrest
1
2
Seat
1
3
Front leg
2
A
Bolt 9
B
Spring washer
9
C
Flat washer
9
E
Allen wrench
1
Flip the seat ② upside down so that the bottom faces you.
Remove the bottom fabric attached by Velcro to get ready for
assembly.Place the backrest ① on a flat surface. Align the seat
② with the backrest, making sure the bolt holes overlap. Fit a
spring washer B to a bolt A followed by a flat washer C. Insert
the bolt into a hole and tighten it with your hand until it is
finger-tight. This will allow an opportunity to level the chair and

Flip the structure formed in Step 2 upside down and place it
along the edge of an elevated level surface to get ready for
assembling the front legs. Fit a front leg ③ into the slot in the
front of the seat. Make sure the curved face is towards inner
side as elaborated in diagram below. Repeat this for the other
front leg ③.
Fit a spring washer B to a bolt A followed by a flat washer C.
Insert the bolt into a hole and tighten it with your hand until it is
finger-tight. Repeat this for the other hole and then repeat the
process for the other leg
Place the loosely assembled chair in its desired location. Apply
gentle downward pressure on the seat to eliminate rocking and
ensure the chair is level. Once the chair is leveled, tighten all