NUCANOE Frontier 12 User manual

Frontier 12 Rowing System
Instructions
1. Assembly Rowing Frame
a. Lay out the Rowing Arm assemblies and Cross Bar as pictured. Ensure cam locks
(circled in blue) are facing up.
https://www.youtube.com/watch?v=wVUIupwo1WM for installation video.
b. Ensure the hand is fully open (in direction of arrow). Then connect ends of Cross
Bar to Open “Hand” piece (circled in red). Align the holes and fasten with the 10-
32 x 1-1/2” Phillips Screws and 10-32 Locknuts.
2. Install Rowing System in Frontier 12
a. Remove Side Handles using 5/32 Hex Driver. Save parts for future use.

S
b. Install Eye Bolts on each Side Handle Insert using ¼-20 Screw, 2 x Washers, and
Black Spacer.
c. Determine Orientation: Note the direction the arms are facing will be the way
you are facing.
d. Insert Rowing System onto Frontier, with the Eye Bolts going through the slots.
Use Lock Nuts and Washers to secure in place.
e.
Solo Forward-Facing
Solo Rear-Facing & Tandem Forward-Facing

e. Connect Ball Joints to Slider on Support Arms. Remove Cam lock & the Top
Flanged Bushing from Support Arm. Install Ball Joint. Reinsert Flanged Bushing
and fasten with Cam Lock.
.
f. Lift the Rowing Arm into position, then tighten the cam locks to lock in place. Do
this on both sides. Insert the oar locks and secure with cotter pins.